WayneB
Elite Member
49 with some light rain now, heading to a high of 51
Hoping for some dry feet this afternoon...
Hoping for some dry feet this afternoon...
Good morning!!!!
- Thread starter 300UGUY
- Start date
- Views: 16038860
daugen
Epic Contributor
48 degrees going up to 71 today, in a steadily warming trend that will go into the eighties (!!) by early next week. And no rain here at all. getting dusty and means I'm back on new plant watering detail today.
David/Sodamo: I think this little smiley says it all: :cloud9:
David/Sodamo: I think this little smiley says it all: :cloud9:
txdon
Super Star Member
Good morning! 64˚ heading to 82˚ variable winds, sunny.
The yellow cat is happy the mower is off the tractor, and the tractor spent the night inside.
I'll work on my remote garden today. It has very sandy soil and I'll prepare it with my 6' tiller so it will be ready to plant watermelons next year.
The yellow cat is happy the mower is off the tractor, and the tractor spent the night inside.
I'll work on my remote garden today. It has very sandy soil and I'll prepare it with my 6' tiller so it will be ready to plant watermelons next year.
wngsprd
Super Member
44 now with 71 and sunny coming up later.
Should be a great day.
Should be a great day.
rswyan
Super Star Member
- Joined
- May 12, 2004
- Messages
- 11,256
- Location
- Northeast Ohio
- Tractor
- Kubota B2910, Cub Cadet Pro Z 154S, Simplicity 18 CFC, Cub Cadet 782
Apparently that was the style ... down in your neck of the woods ...
That's where I bought it ... some 35+ years ago ...
:laughing:
Not terribly likely ... but hey - if that's what ya wanna go with, have at it ... :laughing:... and your wife laughs only when her back is turned.
Buppies
Super Star Member
- Joined
- Oct 26, 2011
- Messages
- 12,017
- Location
- SouthWestern Virginia
- Tractor
- Kubota L5240 EX mark 60 in 29 hp Toro 60inch Z Master 21 inch walk behind Polaris 900 hunter edition 30in toro walk behind
46 this morning high of 67 later and finally wind is going to die down. Tomorrow will be even better high in 70s. This wind has really dried things out and no rain in forecast for a while mild conditions thru mid November
Good Morning
Good Morning
rswyan
Super Star Member
- Joined
- May 12, 2004
- Messages
- 11,256
- Location
- Northeast Ohio
- Tractor
- Kubota B2910, Cub Cadet Pro Z 154S, Simplicity 18 CFC, Cub Cadet 782
36F and cloudy ... heading up to 62F with abundant sunshine ...
Another day or two of sun and no rain and hopefully it will be dry enough to work around the barn.
Got some welding and rebar bending done last night, oiled all the airtools, and did some cleaning and straightening up. Yesterday afternoon I screened about a dozen bucket loads of topsoil to fill in some low spots and cleared all the (previously dumped) grass from the Trac-Vac off the field next to the shop so I can use that for bucking firewood.
Not really tired at this point so I'll stay up until I am.
Probably make the run this morning to TSC for the lower lift pins and hydraulic fluid, NAPA for filters, and Home Depot for the 'crete ... drop off an empty tank at Matheson-Valley along the way ...
Need to clean off the back of the pallet fork frame so I can weld an SSQA plate on it tonight and get them operational again.
Hope everyone has a good day ... except for Don ... (... j/k ... :laughing
Another day or two of sun and no rain and hopefully it will be dry enough to work around the barn.
Got some welding and rebar bending done last night, oiled all the airtools, and did some cleaning and straightening up. Yesterday afternoon I screened about a dozen bucket loads of topsoil to fill in some low spots and cleared all the (previously dumped) grass from the Trac-Vac off the field next to the shop so I can use that for bucking firewood.
Not really tired at this point so I'll stay up until I am.
Probably make the run this morning to TSC for the lower lift pins and hydraulic fluid, NAPA for filters, and Home Depot for the 'crete ... drop off an empty tank at Matheson-Valley along the way ...
Need to clean off the back of the pallet fork frame so I can weld an SSQA plate on it tonight and get them operational again.
Hope everyone has a good day ... except for Don ... (... j/k ... :laughing
ronjhall
Super Star Member
Pour second cup of coffee. 30° with some clouds this morning. Heading to 60° with a mix of sun and clouds. Need to cut lawn one last time. Then rig up Trak-Vac to finish out lawn care season.
Good Morning All.
Good Morning All.
dave1949
Super Star Member
43F, not raining. Should be clearing out today. Sat-Sun is forecast to be dry here.
I'm off to the eye doctor this morning for a regular check-up and it's time to get new glasses.
Our older son is coming for a visit this weekend while our DIL visits her folks in Florida. Haven't seen him in a while so that will be fun.
Have a good one.
I'm off to the eye doctor this morning for a regular check-up and it's time to get new glasses.
Our older son is coming for a visit this weekend while our DIL visits her folks in Florida. Haven't seen him in a while so that will be fun.
Have a good one.
txdon
Super Star Member
Apparently that was the style ... down in your neck of the woods ...
That's where I bought it ... some 35+ years ago ...
:laughing:
Since you did not say Texas or any real location I'm suspecting Oklahoma, or some mild case of dementia.
In my "neck of the woods" we did not even have a MacDonald's 35 years ago much less a welding shop with pretty accessories.
In any event, it is definitely a collector's item and could be quite valuable. :drink:
