NX4510 and NX5010 pricing and review

[GManBart]

I have anti gelling treatment in my Kioti and it still will not run if the temps are under 20 degrees. I got the heater from my dealer and was charged full price. Installed it myself outside, I think it was in the teens. Froze my but off installing it. Works fine. Ran the tractor for 30 minutes then parked it. Hydraulic leak with oil running everywhere. One of the steel tubes that connects to the pump cracked. Oil seeps out. I can run it for a few minutes but that's it. Now I'm looking at $400 to get it taken to my closest dealer 2 hours away. I would change it myself, but the engine oil check tube runs directly over top of the one bolt. You can only get to it with a small wrench and I don't want to strip it. Just majorly disappointed with this tractor.

Welcome to TBN

Since this thread is already way off track, you're probably be better off starting a new thread.

 

[murphy1244]

Getting back on track would be discussing NX pricing and reviews...no need to divert it into yet another topic.

Do you have to correct everybody?

 

[GManBart]

Do you have to correct everybody?

It's okay for you to tell everybody to get back on track to a third topic, but I can't suggest getting back to the actual thread topic?

Pot meet kettle.

 

[murphy1244]

It's okay for you to tell everybody to get back on track to a third topic, but I can't suggest getting back to the actual thread topic?

Pot meet kettle.

Time for this thread to be locked when it gets this far off track.

And always have the last word. kettle meat pot.

 

[GManBart]

And always have the last word. kettle meat pot.

I never suggested you try to get the last word, so that doesn't apply.

Suggesting this thread runs into a third or fourth topic is ridiculous.

 

[TSO]

Did somebody say MEAT? Great, now I'm hungry...

 

[TJP89]

Let's just dump the whole thread and move on.

 

[peterc38]

Let's just dump the whole thread and move on.

Seconded, this is a freak show.

 

[Threepoint]

Did you guys ever see this Kioti brochure: http://www.rtmachinery.co.uk/images/kioti/Kioti_NX_brochure.pdf

It shows the NX4510/5010 having the same engine as the DK45/50 while the NX5510/6010 have the newer engine. I presume it must be a brochure intended for the non USA market. It does have more engine detail than any of the US specific brochures.

Before we leave this thread, I just wanted to point out that the brochure linked to here by Island does not describe the NX4510HST Cab and NX5010HST Cab sold in the U.S. The U.S. models use the newer 3-cylinder engine described for the NX5510HST Cab and the NX6010HST Cab. When I was shopping for tractors early last year, the fact the Kioti had switched to 3-cylinders for the NX from the 4-cylinders in the DK series was initially off-putting. Until I heard the NX run and talked to a buddy who's a Kioti dealer in another part of the country. Wow, is it smooth and quiet.

 

[kapper]

I don't think It would have taken any longer with less power

Great video, although we never got to see the completed project. Took quite awhile to get it down. What tractor is that? Is it hst or shuttle? If that is the 45 hp hst, then I really can't wait to see what my nx6010 will do!!!:licking: