southernAL
Gold Member
Preparing for the new plate and bucket. It's at FedEx right now, hopefully picking up sometime tomorrow
Why no QA bucket on the CK2510?
- Thread starter iptman
- Start date
- Views: 17820
Preparing for the new plate and bucket. It's at FedEx right now, hopefully picking up sometime tomorrow
k0ua
Epic Contributor
Preparing for the new plate and bucket. It's at FedEx right now, hopefully picking up sometime tomorrow
Are you going to convert your old bucket and keep it too? or did you trade it in? I converted my old one, and I still have it even though I traded the tractor off (a Kubota) and of course it fits my new tractor (a Kioti) just fine.
southernAL
Gold Member
I'm keeping my old bucket. I've thought about cutting the ears off and welding a ssqa plate on, but the plate would stick up higher than the back of the bucket. Any other suggestions what to do with it?
k0ua
Epic Contributor
Wait until you get your adaptor and see how it will fit. I am not so sure the plate couldn't fit on it. If not, I guess you could try to advertise and sell it.
southernAL
Gold Member
southernAL
Gold Member
bucket comparison
southernAL
Gold Member
the original pins are not long enough and the new bucket did not come with new ones. I've been In contact with my dealer the past couple of days trying to get longer ones
k0ua
Epic Contributor
bucket comparison
more difference than I would have expected..
southernAL
Gold Member
Just in case anyone is curious, I weighed the adapter plate before I put it on and it was 92lbs. Not sure how much the bucket weighs, but I would imagine it weighs a little more than the factory bucket since its bigger.
