Custom 3 point attachment 2" reciever, Weight Box, Tool Carrier/work table.

   / Custom 3 point attachment 2" reciever, Weight Box, Tool Carrier/work table. #31  
SLICK! That's like a McGyver 10 in 1 gadget tool lol!! I was wrong about the tool carrier/box sitting on the top of it (see post #16 in this thread). It doesn't seem to get in the way like I thought it might. Good job, I'm sure you are getting much use out of that build.
 
   / Custom 3 point attachment 2" reciever, Weight Box, Tool Carrier/work table.
  • Thread Starter
#32  
SLICK! That's like a McGyver 10 in 1 gadget tool lol!! I was wrong about the tool carrier/box sitting on the top of it (see post #16 in this thread). It doesn't seem to get in the way like I thought it might. Good job, I'm sure you are getting much use out of that build.

I should have made the plastic tool carrier a QA setup. it blocks my line of sight backing up to hook up implements.
 
   / Custom 3 point attachment 2" reciever, Weight Box, Tool Carrier/work table. #33  
I should have made the plastic tool carrier a QA setup. it blocks my line of sight backing up to hook up implements.

Well, that just gives you a reason to install a back up camera now!! :D
 
   / Custom 3 point attachment 2" reciever, Weight Box, Tool Carrier/work table. #34  
Very clever project and informative thread.
 
   / Custom 3 point attachment 2" reciever, Weight Box, Tool Carrier/work table. #35  
Very cool set up.... if someone were to put....say a gannon box on that, how would you attach the top connector of the gannon box to your frame? Is that what the pin connector on the top is for?
 
Last edited:
   / Custom 3 point attachment 2" reciever, Weight Box, Tool Carrier/work table. #36  
Very cool set up.... if someone were to put....say a gannon box on that, how would you attach the top connector of the gannon box to your frame? Is that what the pin connector on the top is for?


Nevermind.... I saw a video on youtube....
 
   / Custom 3 point attachment 2" reciever, Weight Box, Tool Carrier/work table.
  • Thread Starter
#37  
Except when I need the PTO, the ballast mostly stays on the quick hitch.
 

Attachments

  • P1030471.jpg
    P1030471.jpg
    800 KB · Views: 237
  • P1030473.jpg
    P1030473.jpg
    542.5 KB · Views: 239
  • P1030486.jpg
    P1030486.jpg
    775.5 KB · Views: 314
 

Tractor & Equipment Auctions

2021 Ver-Mac PCMS-3812 Solar S/A Towable Trailer Message Board (A49461)
2021 Ver-Mac...
2018 Bobcat T590 Two Speed Compact Track Loader Skid Steer (A50322)
2018 Bobcat T590...
P&H OMEGA 20-20 (A50854)
P&H OMEGA 20-20...
2004 Chevrolet C5500 Shuttle Bus (A50323)
2004 Chevrolet...
2015 MACK GU713 DAYCAB (A50854)
2015 MACK GU713...
2011 Ford Ranger Pickup Truck (A50323)
2011 Ford Ranger...
 
Top