Driver friendly work lights

[Aquamoose]

I know everyone has outfitted their tractors with all sorts of work lights that would light up a football stadium but I want to use a pair of “driver friendly” work lights to the front to avoid blinding oncoming drivers when I’m on the public roadways clearing snow. I’d rather that they see me and navigate safely around me. Anyone got any suggestions?

I have some LED lights that has too much light spill and tilting it down won’t be effective. I wonder if there are effective flood/fog lights that would do the job of keeping the lights down to the ground. The lights will be mounted on the canopy.

 

[JK22]

I know everyone has outfitted their tractors with all sorts of work lights that would light up a football stadium but I want to use a pair of “driver friendly” work lights to the front to avoid blinding oncoming drivers when I’m on the public roadways clearing snow. I’d rather that they see me and navigate safely around me. Anyone got any suggestions?

I have some LED lights that has too much light spill and tilting it down won’t be effective. I wonder if there are effective flood/fog lights that would do the job of keeping the lights down to the ground. The lights will be mounted on the canopy.

If you get spot style LEDs and angle them pretty far down, you won’t blind oncoming traffic. You could also look for SAE/DOT rated lights, but the light output is really not impressive for what they cost. Some LEDs have a high/low output, and SAE/DOT rating is on low. I’ve only seen the ones Ridgid makes... and prepare to get out that wallet.

 

[seville009]

If your concern is other people seeing you, a good option is truckers reflective tape. That tape reflects nicely back to cars coming at you far away.

I put the tape on my tractor, skidsteer, truck, and plow itself. On the sides, back, and front. That way drivers will see me when I’m working at the end of my driveway.

Quick and easy solution that really does work

 

[SmallChange]

Just a thought, but, could you mount them somewhat further back and tucked slightly up into the canopy, so that the canopy edge itself shades oncoming drivers? Maybe the work light could only illuminate 20 feet or so of road in front of you. You could even add some sort of beacon more visible from above but not focused on the oncoming drivers.

I've been trying to think through how to do this myself...

 

[oosik]

Aquamoose - I turn on every light on the Kubota plus a rotating beacon atop the canopy. When I get down where my driveway enters the county road. This means - head lights, work lights, rear pointing flood light, emergency blinkers & rotating beacon. I also have reflective tape on the front hydraulic arms for the FEL.

If the drivers can not see this - a couple added lights probably won't matter. So far - 38 years of experience - drivers going either way have always slowed down.

I do this whether middle of the night( extremely rare ) or broad daylight. My driveway entrance just happens to be on a spot where traffic tends to go like a "BAT OUTTA H*LL". They still slow down.

I look like a carnival side show - but that's intentional.

 

[nyone]

You would be suprised how little light you need when theres snow on the ground. Also flashing lights that are bright and aimed at oncoming cars can really blind people.

If your state law required a yellow flashing light get one thats not to bright, again you dont need much light when the ground is white. If your state dosnt require one i would avoid them.

How much time are you really spending in the road wirh your headlights aimed at drivers?

 

[WranglerX]

There two types of accessory lights, "flood" and "fog", fog lights tend to have a narrow vertical beam. If the are mounted somewhat high and pointed down they can really light foreground without projecting to far ahead...

This graphic may help you make decision...

Dale

 

[chim]

It seems to me that all LED lights are obnoxious unless you are looking at them from inside the vehicle. My work lights are uncomfortable to view from any angle while looking toward the tractor. That includes standing far away in an area that they don't even illuminate.

I travel about a mile and a half each way to clear snow at our church. The LED work lights aren't turned on when I'm on the road. The puny factory headlights, four way flashers and LED flashers mounted on the side surfaces of the roof are used. I do have trucker's (conspicuity) tape on different things. Even found some orange reflective tape for here and there.

The L4240 has 4 front, 2 side and 2 rear LED work lights for night work. The picture below doesn't do it justice. I'm guessing the camera sensed there was plenty of light and limited the exposure. The last time I mowed at night, I turned the two work lights on the front of the roof off because the brightly illuminated hood was annoying. While plowing driveways and parking lots last winter I didn't notice it. While watching the cut/uncut area the hood was in the field of view.

 

[JK22]

There two types of accessory lights, "flood" and "fog", fog lights tend to have a narrow vertical beam. If the are mounted somewhat high and pointed down they can really light foreground without projecting to far ahead...

This graphic may help you make decision...

Dale

Huh? Your graphic shows 4 types. I’ve actually never heard accessory lights called “fog” lights. Those come OEM on vehicles. They are almost never added as an “accessory” (because they are kind of terrible outside of real fog and very little bang for the buck in terms of visible light).

 

[Aquamoose]

Believe it or not, I worked as a professionalism the emergency vehicle upfitting business and we cover the aspects about proper lighting usage which is now a hot topic since lighting has peaked out. Studies show that more lighting is counterintuitive and does increase the danger that what was originally believed. I do have a single amber halogen fast rotating beacon from Hella that I use along with rear amber/red LEDs for rear warnings. I’m on a medium county road that leads to the backside of our local airport.

I like the illustration, thank you. I may just start shopping for fog lamps and hope to find a pair with good reviews. I wouldn’t mind going with halogens because I’ll have enough amperage plus I think a warmer color would be better than the cool white color of LED’s. Just thought that there might be LED’s out there that would do the job well. I do need lighting but the last thing I want to do is go with the mentality that drivers will slow down because of bright lights when I’ve seen & heard enough hard evidence to the contrary.

Thanks for the input guys!