10 hour grease job question

   / 10 hour grease job question #31  
Rather than copy/paste each of your examples and address them individually I took the lazy route. Sorry if that offended you. Wasn't the intent.

Those “examples” were direct quotes from the locknlube website (as stated in my post).
 
   / 10 hour grease job question #32  
Those “examples” were direct quotes from the locknlube website (as stated in my post).

Sorry, I didn't see that. I interpretted them as your personal comments. I'll reread your post. Sorry.
 
   / 10 hour grease job question #33  
Those “examples” were direct quotes from the locknlube website (as stated in my post).

Ohhhh,, I reread... they aren't your writings. You simply posted them as (true).

I go back to my earlier post.

(False). :)
 
   / 10 hour grease job question #34  
This thread has me requesting one of my Christmas presents early. Wife got me a nice dewalt gun. Going to go out this afternoon and hit it and the snowblower I just got. Excited to use an electric one for the first time, pump ones suck!
 
   / 10 hour grease job question
  • Thread Starter
#35  
Is dewalt the most common? I seen a Milwaukee and Ryobi not sure how they compare
 
   / 10 hour grease job question #36  
Is dewalt the most common? I seen a Milwaukee and Ryobi not sure how they compare

The dewalt was 40% off the other day on homedepot and so I nudged the wife pretty hard in that direction. I also have about 10 dewalt batteries already so I could get the cheaper version without batteries.
 
   / 10 hour grease job question #37  
If you hold it on I致e never had a single one of those problems. I致e actually never had a single one of those problems with the regular coupler on my Dewalt gun.

There are a few areas around the tractor that are hard to reach and the lock n lube attachment allows me to get in a comfortable position after I locked on the end of the attachment to the zerc fitting.
 
   / 10 hour grease job question #38  
Is dewalt the most common? I seen a Milwaukee and Ryobi not sure how they compare

Both of my Sons have Milwuakee. Much better gun. I bought Dewalt because I already had half a dozen Dewalt tools.
 
   / 10 hour grease job question
  • Thread Starter
#39  
I gotcha I’m going to look into the Milwaukee, has anyone used the ryobi one I have a bunch a batteries for that just don’t know anyone that used it yet?
 
   / 10 hour grease job question #40  
A grease gun with a rigid pipe sucks!!! So does a lever gun. Personal preference. :)

I am with you on this one Richard, yes, pistol grip and flex hose for me. i still have enough grip strength to work the pistol grip gun. When I don't, I guess I will buy an electric one!.
 

Tractor & Equipment Auctions

1995 BEALL TRAILER FUEL TRANSPORT PUP TRAILER (A52472)
1995 BEALL TRAILER...
2010 Ford Edge SE SUV (A51694)
2010 Ford Edge SE...
2006 INGERSOLL RAND AIR COMPRESSOR (A52472)
2006 INGERSOLL...
2000 Kenworth W900 - 3406E CAT Engine - 78,980 Miles (A52748)
2000 Kenworth W900...
1992 JOHN DEERE 544E (A52472)
1992 JOHN DEERE...
2017 Peterbilt 567 Day Cab (A52384)
2017 Peterbilt 567...
 
Top