I vote for Bosch also. We have had ours 6 or 7 years with no problems. And it is so quiet that the only way to know it's on is that it has a small red light it projects on the floor when it's on. And it cleans the dishes very well. And we put plastic dishes in it at any level and the do not melt.
My wife really likes the small top tray that is for putting utensils. It has the bottom tray for plates and pots, the middle tray for cups, and the top tray for forks and spoons. All get completely clean every time.
I know this isn't in the scope of your question regarding review sites, so ignore it if you want.
Do you have a water softener, and is your dishwater fed soft water? That made all the difference for us and our dishwashers that would gradually stop doing a nice job. The orifices were gradually getting plugged with lime and calcium.
Also, our current dishwasher is about 1 year old, low-end Bosch unit with few features. However, it is the quietest dishwasher I've ever heard, and does a really nice job. Only drawback is it doesn't have heat dry, but if I run the thing before I go to bed, the dishes, silverware, glassware, etc... are all dry. The only things wet are the plastic containers and lids.
Good luck in your search. :thumbsup:
I'm on city water and I have never tested my water for softness. I've seen the kits at Home Depot, so I'll check to see if they still have them and find out what my water is like.
Another vote for Bosch. Our trusted Maytag kicked the bucket after 12 years in 2013 and I replaced it with a Bosh. I looked at Consumer reports and talked to friends to get recommendations.
Aside from all of the other great things people mentioned about Bosch, Out of the 5 or 6 dishwashers I have installed or helped install, the Bosch was by far the easiest. The unit comes with all the hoses pre-installed and they come out the back, so you only need to make connections under the sink. Similarly, they supply a junction box with terminal blocks, so you do not need to make connections at the front of the unit. As a matter of fact, the only thing you need to do at the front of the unit is to level the unit by adjusting some hex screws that drive cams-way easier on my back.
Have tried several brands, including Bosch, and can't say any of them are worthy of recommendation. It's a crap shoot. Do your best to sift through the data, and then pick one that has the features and usability you like.