What have you done with/to your GC Series 2300, 2400, 1700 Tractor TODAY

[Dmacleo]

First post - added toolbox storage to GC1710. Still trying to figure out how to attach pics, I tried last week, and logged in today and low and behold I had a pic in my folder. So I will try to post it.

I had never thought to attach there, thats cool will look into something like that myself. thanks for posting that.

 

[GeneV]

First post - added toolbox storage to GC1710. Still trying to figure out how to attach pics, I tried last week, and logged in today and low and behold I had a pic in my folder. So I will try to post it.

Pretty cool.

 

[MoMower]

Little tractor Hiding, before some homeowner requested destruction

 

[irvingj]

Mine's been busy doing the leaf thing.... looks like one more time for this year. My DR Leaf Vac does a very nice job; gets about 98% on one pass.

 

[kenmbz]

DR leaf vac , very nice. Have one of their chippers and it works pretty good.

Anyone try a Granberg Alaskan Sawmill- I must have a few more dozen Ash to come down and could use some benches and a coffee table.

 

[cdaigle430]

one of Irvingj s pics brought up a discussion point that is the one thing I HATE about these GC tractors that come with a BH, not sure if it still affects the newer 1700 series though. The one thing I hate about this tractor is when the top link always hits the FOP bar every-time its folded and you raise the 3ph. Such a horrible setup-engineer who designed this should be shot! Im still trying to figure out how to keep that from happening without heavy modifications. Irvingj looks like you have something wrapped around the top bar of the FOP?

 

[cglaser104]

one of Irvingj s pics brought up a discussion point that is the one thing I HATE about these GC tractors that come with a BH, not sure if it still affects the newer 1700 series though. The one thing I hate about this tractor is when the top link always hits the FOP bar every-time its folded and you raise the 3ph. Such a horrible setup-engineer who designed this should be shot! Im still trying to figure out how to keep that from happening without heavy modifications. Irvingj looks like you have something wrapped around the top bar of the FOP?

I remove my toplink and was advised to do so by the dealer. Only the lower arms fold and I don't have an issue there with clearances. For me it's still nicer than taking off all the arms completely which at last glance was a necessity for orange and green comparables.

 

[kenmbz]

Top link removed too.
Also added a neoprene stick on pad to Rops where they touch BH when folded.

 

[Dmacleo]

First post - added toolbox storage to GC1710. Still trying to figure out how to attach pics, I tried last week, and logged in today and low and behold I had a pic in my folder. So I will try to post it.

is that a homemade tool box ? where did you get it if not?
sort of looks like an ammo can

 

[Puddlewalker]

The Tool Box / Storage Box is army surplus 50 cal ammo box. I paid $10 each. You can pick them up new at Harbor Freight for $15.