mine is leaking...."The reservoir is attached to the transmission via a short rubber hose. What tends to happen on these is that they leak near the clamp." Is there a way to stop the leaking at bottom of the plastic bottle as if I tighten more al that happens is the clamp crushes the bottom of...
What Diameter are the bolts that come with the bar I understand there are 2 for the sides of the bucket and 3 to 7 more that can be through the buckets existing cutting edge I would like to know the diameter of both sets of bolts. That are supplied with the Toothbar....Thanks
https://www.farmshow.com/a_article.php?aid=16114
Just came across this. I ain't 86 yet so I have time to build one and trim some more tall trees ?? Or at least tie a cable up high. I don't think it is OSHA approved
If it was just a windrow I wouldn't mind, Its more like it leaves the grass after the first pass about 8 to 12 high and if I back up and then pull forward it is cut to my satisfaction. I was just wondering if something was bent or does the TW72 just cut grass this way because its more for...
I have a Rhino TW72 bought it used I am third owner
I have a slip clutch on the the drive shaft. It works great on large stuff up to about 4" or a little bigger. But when I cut tall thick grass, it cuts most of it, but leaves some of it a bit tall some after a single pass may be 12 to 16 " high...
Not a lube question but perhaps you can help me
I have a Rhino TW72 bought it used
Originally it was owned by a Cemetery (must have been in the foot hills as it has a few scars I would guess from large rocks???
I have a slip clutch on the the drive shaft. It works great on large stuff up to...
My brother's1538 HST ran out of fuel going down hill he said the tractor would not roll down the hill and it couldn't be towed as it seems to be locked up. Can he be correct ??? I thing he is wrong! Anyone know of any reason the tractor would not roll down the hill after running out of Diesel...
lx178 john deere mower with Kawasaki 2 cylinder FD440V motor.
I went to start mower this morning turned key to the start position, I was sitting on seat, with my foot pressing down on the brake pedal and the PTO clutch was disengaged. Turned key all sounded normal sound of starter solenoid...
Tractor is a Kubota M 5140HD, First I am not sure if the cover is plastic or glass it is covered in thick dust. I would guess I should clean it with a damp wet micro cloth as if it is plastic I do not want to scratch it. How do you clean yours and how can I tell if it is glass or plastic
Thanks
Anyone have hands on experience with this Walabot ?? Thanks
Official Walabot DIY Deluxe Bundle | Lowest Price | All In One Stud Finder
Website: Official Walabot DIY Deluxe Bundle | Lowest Price | All In One Stud Finder
Video demo:
WalabotDIY-Avoid DIY Catastrophes - YouTube
I usually place bales of hay on the trailer deck (they come even with the sides) to allow the forklift to just place the palletized load on top of the hay, for instance a palletized bundle of corrugated tin. But I hate having to mess around loading and unloading the hay and raising the center...
Anyone with a Kubota B1750 or B1550 ? when you place the key in the run positon (before turning the key to start engine positon) do any of the panel lites come on? I would guess the low oil and charging lite would come on ???
My friends tractor will not start. B1750HST-D is the model, panel...