Recent content by liamcward

Hmmmm that is pretty much exactly the symptoms I was experiencing however

I actually haven’t checked the tensioner since replacing it. I did the belt and pulley just out of precaution after buying it, because I had no idea when they were last done. I cracked into there today and got it all snugged up. Figured that was my easiest first step anyway! I gave it a little...

No noises, just very slow to lift or tilt up. Like there kids no power, but drive is still fine.

Hey Guys - Getting an odd intermittent problem on my 2014 G series. My arm lift and tilt up are become very slow - no power to lift at times - but the problem has come and gone intermittently. Everything tilts down / lowers just fine. I also have no problem with drive. Is there something...

Hey Laurence! I’m in Ontario, just north Orangeville! Where abouts are you?

Sorry guys - I wasn’t getting the updates for the responses for some reason! I’ll look up those part numbers and see if I can find the links. I got it all just down at Princess Auto!

Hey Guys - Decided to make use of this no snow time to finally go ahead with upgrading to some of the lights to LED kits. I had some burnt bulbs and a damaged housing already and found some pretty good Black Friday deals down at Princess Auto. I ended up going with a light bar across the front...

I pulled and carefully but thoroughly cleaned up the Mass Airflow Sensor and the Intake Manifold Pressure sensor today. I’ll give it a run tomorrow and see how it goes.

Hmmmm my ECU is pretty much brand new. But I will take a peak and see if there’s anything that’s built up around it since I installed it. Thanks for the suggestion!

Sorry I should have mentioned that in the OP. It’s a 2014 G series

Airflow Sensor?

This one has got me stumped. I’m getting Error Code 108-03 Barometric Pressure Fault if I run the machine somewhat hard - once it warms up. If it shut it down and let things cool off a little, it goes away. When the code comes up there is a noticeable decrease in engine performance. All I...

Curious if anyone has added a strobe light to their TC? I’m spending more time in the road helping neighbours clear their plow berms and we get lots of blowing snow / low visibility conditions. Thinking something a little more than 4-ways on our country road may be a good idea. I see...

Hey Guys! Just wanted to provide a quick update on where I ended up with this issue. I was able to use the machine wit traction control disabled without and issue until I began getting an intermittent 66-04 error code (no ECU communication). Until one day everything stopped dead.. on the road…...

Dealer was able to lookup the code for me. Speed sensor related. He suggested it could either be lack of signal or issue at the wiring harness.