number two's latest activity
-
Nmx would prob handle the pto hp of a 8' twin, but the sheer size weight & maneuverability of a 3ph lift imho & the compact tractor would...
-
Nnumber two reacted to Complete Turf Care's post in the thread Pictures from an athletic field contractor with
Good Post.
More lip removal today. We've done lots of work at this field over the last few years. -
Nnumber two reacted to 3930dave's post in the thread Your last generator Maintenance Run with Good Post.
It's hard to understand the dryness, till you are in it for a while. People think they'll like mesh (well ventilated) motorcycle gear...
-
Nnumber two reacted to 90cummins's post in the thread Your last generator Maintenance Run with Good Post.
Nice load bank!! I use a large 3 element that I use. Each element is switched desperately for a total of 9+-kw. If I need more load 1...
-
Nnumber two reacted to daugen's post in the thread Your last generator Maintenance Run with Good Post.
at least my portable plugs into a 50 amp direct wired house connection, so if I turn off water heater, I can get by with 45 amps. No...
-
Nnumber two reacted to 4570Man's post in the thread $10K L5030 Plus Restoration, or $25K Newer Tractor With Perilous Electronics? with Good Post.
I wouldn’t buy a tractor with the plan of fixing it up. Parts are expensive and labor is expensive. It’s cheaper and easier to just buy...
-
Nnumber two reacted to Jstpssng's post in the thread Kubota L3301 won't throttle down with Good Post.
What year is it? If I recall correctly they have a 5 year warranty.
-
Nnumber two reacted to mike69440's post in the thread I hope I can prevent this from happening to other operators. with Good Post.
I am about 4 weeks behind in the healing process. After a second operation to stabilize my fibula by adding a second plate and a bunch...
-
Nnumber two reacted to CalG's post in the thread Kubota front axle, hydraulic fluid or gear oil? with Good Post.
They mix just fine!
-
Nnumber two reacted to CalG's post in the thread Kubota front axle, hydraulic fluid or gear oil? with Good Post.
Except ...I have read...... UTTO Prolongs seal life over gear oil. So if you don't need the EP properties of sulfur, Go UTTO! I use...
-
Nnumber two reacted to repete's post in the thread how much gear oil for a woods RC-5 rotary cutter? with Good Post.
80-90 vs 75-90, not difference in my mind. The fact is it is going to really like regular changes with clean grease. I have for years...
-
NI do the parking cone funnel at work for the diesel generators… can’t spill a drop because spills trigger reporting and mitigation.
-
NI've never seen a small aircraft without a fuel sump under the tanks. It's at the low point. You push a glass tube up under it and drain...
-
NI bought new pour spouts for all my new gas and diesel jugs. Drilled a 1/2" hole in the jugs and added the vent in all of them too...
-
Nnumber two reacted to KubotaGuy810's post in the thread Kubota B3350 wont start.... AGAIN with Good Post.
Ran a wire from ignition to starter and starts up just fine. Got it back to the shop. Now it'll be easier to check all the safety...