Recent content by rockyridgefarm

Thanks! This is my second round of this. They replaced it all under warranty but never actually fixed it. It ended up being the lift pump. something is really sketchy with that little pump

Thanks for all of the ideas! So for, no success finding a DIY way to reset the codes. I did find the interface:

I disconnected the negative lead and jumpered it to the positive over night. No help. Thanks, tho

I never thought to look for an ODB connector. Will look!

zi sm just hoping that this is possible. I have fought an issue with the fuel rail with my YT347/ It made several trips to the dealer and they tried everything and never could fix it. So, the warranty ran out and Yanmar refused to extend the coverage for the same issue that they couldn't...

I am looking for specs on the block heater. I show 1" NPT - can anyone confirm? TIA -mike

First. apologies if this issue has been covered fully - I just can't seem to find anything with 'search'. If there IS a discussion - please point me to it! I am changing the twin pto belts and the new set seems way too short. I bought a G1800S earlier this year which needed Front PTO Belts...

Started mowing with a new to us B2150. It came from a well respected equipment dealer and seems to have been well cared for. The issue is that is seems to run pretty hot, and it isn't summer yet. The temp gauge is at about 75%. Is it normal to run so hot for this machine? Any suggestions? Oil...

Hi. I need a mower for close to the house. We really don't want a Zero Turn. I've had a Deere SST16 Spin steer that we have liked but they certainly have issues. I found a Kubota G1800 4 Wheel Steer that looks like it would do the job. A diesel mower for way south of $2000 (if it were a ZTR...

I am getting an error fairly frequently. A re-boot helps sometimes; it didn't today Here is the handy description from the manual: Anyone have an idea what this is? TIA

They suggest stocking up now...

What am i missing? When I shift the transmission into 'A' range the engine speed drops almost to idle and won't budge regardless of position of the throttle lever or foot pedal. I don't see anything in the manual that would guide me. I admit that I haven't spent a lot of time on this

I know better than to accept bales that are wrapped in twine instead of net. But, I goofed, and got a few. Some twine got wrapped around my right rear axle. And, of course, will be drawn into the axle seal. Which will end up meaning replacement. Does anyone have access to The service...

Each use reinforces the choice that I made with my YT347, it keeps pulling trough as being well executed. I think that there are a few things that still could improve the buying - ownership experience. Mostly on their website. I think that an effective website goes a long way in leveling the...

After living with my YT347 for a bit, here are my thoughts. I still consider myself new at this; I willl learn more. Of course, I am expressing my opinions and others may see things very differently. I hope others will chime in. I also have the open station. Cab owners will have some other...