Recent content by wallace

why would you want to attach a slide hammer? Remove that seal and then take the nut loose!

We have replace several shift forks in the DK45s over the years...That in my opinion is just a Band-Aid.... The last 2 I did I fixed it right!! Of coarse that again is just my opinion. The problem that I seen with the set up is, the shaft coming from the forward/reverse lever down through the...

Ran long enough to ruin the motor.

Why is this anymore riskier than shoving your loader into a bank or a pile of dirt? You dont put equal pressure on the loader arms when pushing into a pile? I have plowed for 10 years with a loader mounted plow. My first was a 30hp Cub Cadet with a Meyer 7-1/2' plow and now this one. This is a...

Keep in mind that they may also be looking at yours! Not just our dealer lots!!! The following notice has been reported to NEDA from a Member/Dealer: From: PSP Watch Center SP - Strabane Police Date: 04/09/12 Statewide - Auto Theft Ring: As per BCI Western Auto Theft Task Force -...

Woods does not list a mount for the Bobcat CT225. You have to use the mount for a Kioti CK25,CK27,CK30,CK35 Same mount, bolts right up!

I would say take a closer look at the Bobcat! Its powered by a Yanmar diesel, comes standard with power steering.

Well this may help all your questions..... Now for the BIG ISSUE..Got a call from my rep today, seems there is a very limited supply of max 22's I received 1 max 22 and 1 max 28XL I took about 10-15 pictures in the areas that differ the most. I am not going to post all the pictures on here. If...

Hmmmmm.

I would be all over doing this! I love to fabricate! If I was so busy doing this!

Make sure you did not shear off the roll pin.#21 If I am reading your post correctly, I am thinking something got jamed up in there and forced the lever hard enough to bend the bracket for the micro switch. You also mentioned you had to tap the lever (#20?) back onto the shaft #16?. That really...

This is just a orange paint job.

What number you need?

Looking for a very low hour JD 4300 hst 4wd mid mower and loader a plus! Will travel anywhere if the deal is right. CASH IN HAND! Send pictures to rwallacetractor@echoes

No disrespect taken. Okay so $6,000 installed with remote valve. See just like Staples! $1,000 savings :licking: Need it financed? I'm sure we can do that also!