Search results

I'm about to begin repairs on a TMG 72 inch tiller....I purchased it used and the gear box input seal is leaking and possibly the gear drive box seal is as well....in my town there are no ag dealers. I can drive to a Kubota dealer 30 miles away but my question is will a seal from NAPA or...

I have purchased a used TMG tiller I serviced it today and ran it for the first time. I’ve never run one before so I have no experience with one. So while running it for a test I noticed when running into some coastal Bermuda the clutch slipped. It made quite a racket so I lifted it a bit to re-...

I have a large oak tree that the wind blew down along our creek. It’s probably 50 ft or so tall and trunk diameter of near 36 inches. I plan on piecing it out with a chain saw and using my MX5400 to drag the cut pieces out. My question is:due to working along the creek bank I’ll have to use...

I have a TMG 72 inch tiller I bought used...I haven't operated it yet so I hope it's OK...I have received a manual from TMG so hopefully it has the information I need...I want to change the oil in the gear drive end and the gear drive housing...not sure how much oil to fill either....comments...

I have an MX5400 which is a Cat1/2 system...I'm looking to get a set of Pat's quick hitch adapters and I'm thinking I should order Cat 1....does it make a difference and has anyone put Pats on their MX5400? Any feedback on experience with them. All my equipment is Land Pride but one TMG...

I have a Kubota MX5400. We have three 16ft. trailers on our place that we move around time to time. I want to use the tractor to do this instead of using my pickup. Do clamp on bucket ball hitches work or an A frame three point work better or suggestions on something that works for you. I know...

I have a Kubota MX5400. Been doing a bit if shredding and box blading. I pulled my screen and used a blower to clean it up. Then I used a water hose spray to clean the radiator. Problem is access to wash from the back side washing out because of the fan. Anyone have a method of washing out the...

I have a front tire on my Kubota MX5400 leaking. Any recommendations on tire sealants thanks

I have a Landpride 2072 shredder and the rubber front guards are ripping off. I've looked at Chains and they are close to $300. Rubber replacements are $25. Has anyone used anything different that is more durable than the 1/4 inch or 3/8 inch whatever it is or should I just go ahead and rebuy...

Has anyone figured a homemade way to put a bucket level indicator on your Kubota. I have a MX5400. Mine didn’t come with one and I didn’t know I needed that add on. It’s not that I’m cheap to buy an OEM one I just know lots of you guys are innovators. If you have something photos are good.

I have many hogs on our property. When I’m out on the tractor I’d like to carry a rifle. Has anyone done a carrier or have suggestions on how to do so. I have a 22 with a scope that I’d like to carry. Thanks

im needing to grease the rear ujoint on my shredder. The shroud with the hole and side doors doesn’t make it any easier. Also if I want to slip the clutch the side doors are difficult. Has anyone removed the shroud and can explain how to do it. If I could take the rear shaft off I’d do that but...

We purchased a property 2 years ago that has 50 acres of wooded and creek area and 30 acres of areas that can be developed into a pasture. We are currently doing wildlife management, but I’m trying to decide on whether it’s worthwhile to develop some or all of the 30 acres into pasture...

I Purchased, a Northstar spray rig 26 gallon tank with a 5 gallon a minute pump. I started calibrating it yesterday and it appears to me that the 5 gallon a minute pump is a lot more than I need for what I am doing on our place. Basically small food plots and I was setting up to control grass...

I'm not one to re-invent the wheel so I'd like to ask your recommendations on a brand of sprayer for my Kubota RTX-1140 side by side. I will be doing food plots for wildlife management...probably less than 1/2 acre per plot...I'm believing that a 25 gallon spray rig will be sufficient to do 3-4...

We have a creek that runs through our property. To access the backside we had to build a bridge about 30 foot long to get across. Recent rains have caused a log jam at the bridge support pilings. Has anyone built an attachment that either will go on your bucket or if you’ve taken the bucket off...

We have a lot of hog damage on our property that we recently purchased and I have secured a 10 foot railroad iron to manage some of the damage. One of my concerns is attaching the drag to the back of our tractor and also the UTV. my concern is the pull cables getting into the tires and possibly...