Search results

Howdy, Was wondering if any company made an attachment that essentially screws a metal post in? There are a couple companies here that essentially look like they made their own using a hydraulic motor and different types of transmissions... They are usually on a bx or atv platform with a 6...

Morning gentlemen, I stumbled across a rear scraper blade that has hydraulics to make the blade lay down, I.e. it doesn't appear to even be able to turn left or right simply "flatten" out (moldboard more parallel to the ground) or raise (mold board becomes perpendicular to the ground). I...

Anyone make or figure out how to hook up a psi gauge and correlate it to the weight inside the bucket ? The systems I see for sale use this principle but are really expensive and I was looking to get something going to figure out the weight of some things I load into my trailers and how much...

Hello, Just got around to pulling out a pin that was made 2 years ago for my backhoe, Original pin was too short since I added a hydraulic thumb to my backhoe and decided to use an existing pin slot in my backhoe. Long story short, after pulling it out I noticed two indents in where the...

I just ordered a 2inch water pump to have around the home, What are some attachments or "accessories" you guys recommend for it? I'm thinking a 50ft long dump hose and a 20ft suction with a filter. How do you guys have yours set up? Have any of you built a rack for one? Primary use is to...

I have a standby diesel generator that leaks oil since day 1. The issue is, I have looked EVERYWHERE for the leak and cannot find it. Here's where it gets even more confusing : the engine oil is dark (like normal used oil), while what I find on the floor is a lot lighter. I.e. like new...

Evening ladies and gents, I'm wondering what you guys use to heat the garages? I have two garages which are well insulated (r30 walls and r40 ceiling) in one and In the other, around r24 walls and r30 ceiling). Both are around 14ft by 30ft with 9 feet high ceilings. Most of my garages have...

Hello guys, I ended up deciding and getting an almost new tractor (200h on clock) this summer. A Deutz-Fahr Agroplus 430. I absolutely love it, starts at -20C without being plugged in. Beast of a machine. I was wondering if anyone here knows if there's anything to watch out for? And does...

Hello guys, I was wondering where all of you keep your attachments and how do you store them? This is mostly for winter storage. I mostly place all of mine on a couple of cinder blocks and 2x6s to try and prevent them from freezing to the ground, but all of mine are pretty much snowed in now...

Good evening everyone, I just took delivery of a used ZD326. It's a 2008 with just over a thousand hours. Now I don't have a owners manual which I plan on ordering Monday as well as a service manual, but until then the weekend is long and loads of work can be done. What should I check...

Alright so I have a question concerning pto's. Being somewhat new to tractors and only owning one PTO attachment, a 5 foot Harley Rake, it has a recommended PTO hp range of 18-32. My current tractor has 16pto hp, and having used the rake this summer it did a fair job. I had to slow down abit...

I got the idea of attaching a hydraulic pump on the PTO; with a large reservoir and a really long hydraulic line (tucked in a pipe). I am talking a 100 foot long line.. It would be used to run equipment far away from the tractor... Would this idea work? Assuming you have a pump that puts out...

Evening Gentlemen! Today I have been using my Sc2450 to level a piece of my land (Use the loader to carry sand); and after my post ride inspection; the little lever under the seat to bypass the transmission was down (activated). It could have fell down while i was riding (rough ride); and could...