Search results

I was brush hogging heard a noise Then lost hydraulics to power steering and rockshaft. Big gear was broken in two and most teeth were gone. Small gear was broken in two and also had many teeth missing.

Thank you for your in-depth precise answer

I have a John Deere 1020 serial #79000. Gas engine serial #123000. Does the engine and clutch need split to put seal and bushing on tach input cable. Also does the end of tach have a seal to keep oil from going up cable. From what I see there is a bushing I believe T31437. Can it be put on...

Ok thanks

I have a jd 1020 gas serial no 79000. Lost power steering and rockshaft function. After two splits clutch then transmission I found transmission pump gears destroyed. I installed new gears. I ran a magnet in the input and output lines and removed many teeth and metal pieces. Also installed a...

Found the problem. Two bolts inside shifter cover

Just did a clutch to engine split to check clutch plates and splines on John Deere 1020. I have no fluid going from transmission pump to front pump. Everything looked good in clutch. Put back together in a couple hours and started on transmission to clutch split. I can’t get it to separate...

Replacing rear main seal. Do I need any type of retaining compound on wear sleeve of seal. If so which type.

You are right Jim. Engine is 123000,

Yes serial number is 79000. Thanks for everyone’s help

Does anyone have a parts number for packing or seals for the low pressure lines going to the housing on jd 1020

I can turn both shafts by hand. Thanks for heads up on washers and tool That tool doesn’t come cheap. But while I’m in there might as well change it.

Split tractor at engine and clutch Splines on pressure plates and shaft look ok haven’t taken pressure plate assembly apart yet. May change rear crank seal and throw out bearing while apart. Put back together then split at clutch transmission. To see what transmission pump looks like..

Thanks for everyone’s help

Would I be able to drive it 300-400 yards to garage to work on it without doing any internal damage it is in field now

Took filter off and ran tractor. No fluid came out

I have live PTO. Took low pressure lines off at front pump and had no flow. Will check flow at filter.

Oil level is fine. I just drained and pulled the screen. Hardly anything on it. Next I pulled the filter and I looked fine. Pulled the bypass valve next it looked ok and wasn’t stuck. There was no oil going to the main pump in front from the transmission pump.

I have a jd 1020 serial number high 79000. I have no power steering and no rokshaft function. I have checked the screen and filter they seem fine. Checked front mounted hydraulic pump no flow to pump . Looked in hydraulic fill didn’t see any spraying. Is next move to split tractor and look...