OP
Workin fool
Member
Took filter off and ran tractor. No fluid came out
I would remove the front pump coupler to be safe.Would I be able to drive it 300-400 yards to garage to work on it without doing any internal damage it is in field now
Can you turn the shaft that drives the transmission pump by hand?Split tractor at engine and clutch Splines on pressure plates and shaft look ok haven’t taken pressure plate assembly apart yet. May change rear crank seal and throw out bearing while apart. Put back together then split at clutch transmission. To see what transmission pump looks like..
Can you turn the shaft that drives the transmission pump by hand?
Rear seal requires a special tool to install the new seal.
Be sure to use new packings (rubber washers) on the two oil lines to the lower right transmission case. View attachment 700653