fuel tank

I want to weld some skids on my 55 gallon drum for diesel fuel. The skids would allow me to put a drain in the bottom so the drain, pipe and valve wouldn’t get damaged. However, if I weld on the bottom rim will it leak afterwards?

Its been a while sense I posted anything. I have about 680 hours on my TYM t353 and had to replace control module at around 400 hours my 2nd problem is leaking fuel tank has anyone else have problems this problem. Tractor has done a great job! Ron

The original plastic fuel tank on my 2006 PT-425 began to leak around the bottom hose fitting. I replaced it with a new aluminum tank purchased from Powertrac. I also replaced the fuel line and fuel filter and added a shut off valve (something that I've wanted to do for years). Not sure if I...

I am looking for a B and S Fuel Tank, OEM part #297257. I am even open to good used. This is an old 70's engine, but runs great. Gas Tank rusted through.

Hi I'm new to the group and I'm working on a free Ford 3000 diesel. It's not locked up so that's a plus. Was told it was having issues with getting fuel. So I'm going to start with cleaning the lines then go from there. The question I have is are all of the Ford 3000 fuel tanks the same? They...

1996 JD 6200 Open Cab: I refuse to believe that I have to buy a whole new fuel pump to get a new filter/strainer that is installed on the end of it. Dealer wants over $100 for a new fuel pump. I would think the filter on the end would only be a few dollars and should be a separate part. Does...

So the rubber bushing on the bottom of my fuel tank gave out and I bought a new one to replace it. And thanks to the "TC33 fuel tank removal" thread, will replace the fuel line with the Gates Barricade hose. Do I have to remove the tank to replace the bushing? Trying to plan for the worst case...

We purchased new in 2011 a Mahindra 3016 Shuttle We have had LOTS of issues with there being debris in the Fuel Tank like metal and plastic little pieces. We have gone thru LOTS of fuel filters and also had a repair guy try to remove as much debris as he could with tweezers. Now even after...