LD1
Epic Contributor
Personally, I would just tap them out to 5/16 then. You are only talking about .050" of material. Thats only .025 per side...Thats not much loss of material.
1/4-18 thread machine screw?
- Thread starter cockeyedMFer
- Start date
- Views: 23609
OP
cockeyedMFer
Gold Member
- Joined
- Jul 25, 2011
- Messages
- 270
- Tractor
- 1959 MF 35 deluxe, gas
Good suggestion. The mystery of it is what bugs me...who in the world was making 1/4-18 fasteners in the 1950's? Hasn't everything been UNF since the 30's? I have seen unique threads on early American cars, but this is a relatively "new" window compared to the cars.
oldnslo
Super Member
Dumb question but are self tapping screws? Possible that someone like CamCar made them special per customers request just to have the "repair" / replacement business. I know CamCar made a lot of specialty screw products and I am sure other companies did also.
Mace Canute
Elite Member
I went looking through some Thread Specifications but couldn't find a 1/4-18 thread listed. My guess would be that it was a proprietary thread spec'd by the manufacturer. :confused3:
Midniteoyl
Super Member
- Joined
- May 20, 2013
- Messages
- 5,114
- Location
- N. W. Indiana
- Tractor
- Kioti CK3510SE HST, Ford 3400, Gizmow ZTR, Simplicity 7016H
Are you sure its not a #14 Type B point sheet metal screw? It prolly is. I bet the thread gauge leaves some daylight, correct?
#14 .25 1/4
Type B point: A thread forming screw for use in heavier metal .050 to .200 thick. Larger root diameter with finer thread pitch for light and heavy sheet metal non-ferrous castings, plastics, impregnated plywoods, asbestos combinations, and other materials.
PeterK
Gold Member
Maybe bspp threads 1/4-19 ?
bandaidmd
Platinum Member
i think you nailed it! or would that be screwed it for this thread.
Soundguy
Old Timer
- Joined
- Mar 11, 2002
- Messages
- 52,424
- Location
- Central florida
- Tractor
- RK 55HC,ym1700, NH7610S, Ford 8N, 2N, NAA, 660, 850 x2, 541, 950, 941D, 951, 2000, 3000, 4000, 4600, 5000, 740, IH 'C' 'H', CUB, John Deere 'B', allis 'G', case VAC
a m4 would be 17.8 tpi right?
OP
cockeyedMFer
Gold Member
- Joined
- Jul 25, 2011
- Messages
- 270
- Tractor
- 1959 MF 35 deluxe, gas
Actually, its a perfect fit with the thread gauge. Also matches with a 5/16-18 threads when stacked on top of each other.
OP
cockeyedMFer
Gold Member
- Joined
- Jul 25, 2011
- Messages
- 270
- Tractor
- 1959 MF 35 deluxe, gas
M7 is the closest in diameter, but none of the thread gauges match
