3pt top link tilt w/ electric actuator
- Thread starter Twanger
- Start date
- Views: 11655
Pooh_Bear
Platinum Member
- Joined
- Jan 2, 2005
- Messages
- 763
- Tractor
- Early 1949 Ford 8N
I've considered the idea and wondered if it would work.
Pooh Bear
Pooh Bear
HomeBrew2
Banned
I've considered it and even found some online (linear actuator). Seemed to handle the lifting load for a couple hundred bux but was concerned with impact load like when snaging rocks with a box scraper ...
We're listening /forums/images/graemlins/wink.gif
We're listening /forums/images/graemlins/wink.gif
hobbyfarm
Veteran Member
I wonder if an electric linear actuator could withstand the forces of tension and compression that the top link might see.
The ones I've seen look way too light duty and they tend to have a short lifespan.
It just seems like the wrong tool for the job.
The ones I've seen look way too light duty and they tend to have a short lifespan.
It just seems like the wrong tool for the job.
ronjhall
Super Star Member
Just saw this thread. Click Here
Looks like what you are considering. Just add ball ends.
Looks like what you are considering. Just add ball ends.
Sorry I was out yesterday and attachments seemed to be broken when I checked. Here is a link I was looking at:
http://www.nookindustries.com/CCactuator/CCactuator_12VDC.cfm
Just a thought. This would simply let you adjust tilt with no load. I mean you could have an attachment on but not engaged in the ground.
Thoughts???
http://www.nookindustries.com/CCactuator/CCactuator_12VDC.cfm
Just a thought. This would simply let you adjust tilt with no load. I mean you could have an attachment on but not engaged in the ground.
Thoughts???
What about price? I have a Bobcat snowblower that uses a linear actuator for the chute deflector. Unfortunatly it was busted when I bought it. Cost new from the manufacturer is >$600. I have seen a bunch on ebay go for a lot less, but you have to watch out for the specs.
have seen some car jacks for flats that plug into the cig lighter. motor runs scissor jack. the jack would take the beating the 3 pt. would dish out so a hefty jack could be adapted to to take a fairly light motor. the mech advantage would put little strain on the motor. thoughts?
Some jacks built as jacks and not actuators are strong in only one direction. For example, trailer tongue jacks have bearings and support for compression and not tension. Top links need strength both ways.
Something more to think about when planning.
Bruce
Something more to think about when planning.
Bruce
