Adding 4wd to YM2310

   / Adding 4wd to YM2310 #11  
I hear you on slippery slopes. There just isn't an answer to using a FEL with 2wd on much of a slope.
The reason is simply that all the weight is out front which lifts the rear wheels ....turning poor traction into no traction.

I went to wide tires and ran chains all the time. Eventually I made up a set of really good fitting automotive chains that fit like skins on wider rear tires and that helped some. A friend of mine went one step farther on his heavy Massey 2wd. His Massey didn't have power steering so a FEL would have been pointless even if he had been able to find a subframe for his tractor and then find a front end loader to fit that, beefed up the hydraulics. etc.

So instead of all that and still ending up with an FEL on a 2wd, he put a reversible dirt scoop on the 3pt. That put the weight over the driving wheels, lightened the steering, and he got by for 20 years. I used to kid him that his solution was just good enough to keep him from ever getting a decent 4wd tractor with loader.

Back in the day when all tractors were 2wd, it was rare to see a Front End Loader on any tractor. What you are experiencing is probably why loaders never got popular back then. In fact, a lot of tractors up until fairly recently didn't even have the necessary frames for mounting loaders. Most tractors were a connected series of castings from front to back. The axle pivoted on the front of the engine casting and the rear axles stuck out the sides of the aftermost casting.....with a cast bell housing bolted to a cast transmission inbetween. So not only was there no loader, there wasn't even a place to mount one. The solution to that was to buy an aftermarket steel sub-frame to connect the front and back of the tractor together. Those subframes were specific to each tractor.

A 3pt reversible dirt scoop isn't such a bad solution.
30-Reversible-Dirt-Scoop-for-Compact-tractors.jpg_300x300.jpg


rScotty
 
   / Adding 4wd to YM2310 #12  
I hear you on slippery slopes. There just isn't an answer to using a FEL with 2wd on much of a slope.
The reason is simply that all the weight is out front which lifts the rear wheels ....turning poor traction into no traction.

I went to wide tires and ran chains all the time. Eventually I made up a set of really good fitting automotive chains that fit like skins on wider rear tires and that helped some. A friend of mine went one step farther on his heavy Massey 2wd. His Massey didn't have power steering so a FEL would have been pointless even if he had been able to find a subframe for his tractor and then find a front end loader to fit that, beefed up the hydraulics. etc.

So instead of all that and still ending up with an FEL on a 2wd, he put a reversible dirt scoop on the 3pt. That put the weight over the driving wheels, lightened the steering, and he got by for 20 years. I used to kid him that his solution was just good enough to keep him from ever getting a decent 4wd tractor with loader.

Back in the day when all tractors were 2wd, it was rare to see a Front End Loader on any tractor. What you are experiencing is probably why loaders never got popular back then. In fact, a lot of tractors up until fairly recently didn't even have the necessary frames for mounting loaders. Most tractors were a connected series of castings from front to back. The axle pivoted on the front of the engine casting and the rear axles stuck out the sides of the aftermost casting.....with a cast bell housing bolted to a cast transmission inbetween. So not only was there no loader, there wasn't even a place to mount one. The solution to that was to buy an aftermarket steel sub-frame to connect the front and back of the tractor together. Those subframes were specific to each tractor.

A 3pt reversible dirt scoop isn't such a bad solution. View attachment 738681

rScotty

Even a 3PT REL is a good option too. It behaves like a FEL, but in the back. A bit more ability than a pond scoop. Each has their strengths.

1648055220063.png


1648055247177.png


A 3PT REL has a strong advantage, the bucket comes off/on easily.

With a hydraulic top-link, variable dumping tilt can be had.
 
   / Adding 4wd to YM2310 #13  
I hear you on slippery slopes. There just isn't an answer to using a FEL with 2wd on much of a slope.
The reason is simply that all the weight is out front which lifts the rear wheels ....turning poor traction into no traction.

I went to wide tires and ran chains all the time. Eventually I made up a set of really good fitting automotive chains that fit like skins on wider rear tires and that helped some. A friend of mine went one step farther on his heavy Massey 2wd. His Massey didn't have power steering so a FEL would have been pointless even if he had been able to find a subframe for his tractor and then find a front end loader to fit that, beefed up the hydraulics. etc.

So instead of all that and still ending up with an FEL on a 2wd, he put a reversible dirt scoop on the 3pt. That put the weight over the driving wheels, lightened the steering, and he got by for 20 years. I used to kid him that his solution was just good enough to keep him from ever getting a decent 4wd tractor with loader.

Back in the day when all tractors were 2wd, it was rare to see a Front End Loader on any tractor. What you are experiencing is probably why loaders never got popular back then. In fact, a lot of tractors up until fairly recently didn't even have the necessary frames for mounting loaders. Most tractors were a connected series of castings from front to back. The axle pivoted on the front of the engine casting and the rear axles stuck out the sides of the aftermost casting.....with a cast bell housing bolted to a cast transmission inbetween. So not only was there no loader, there wasn't even a place to mount one. The solution to that was to buy an aftermarket steel sub-frame to connect the front and back of the tractor together. Those subframes were specific to each tractor.

A 3pt reversible dirt scoop isn't such a bad solution. View attachment 738681

rScotty
I have the same Rear scoop. Use it on the 2wd YM2000 and never cared to have a FEL. since. Many Hrs. on the JD. with one and not having the loader up front while mowing is the biggest plus or using any rear implement for that matter. Besides a few hundred dollars new to a few Thousand. Had it a while.............. Extra set of pins added is well worth it for easy reversing.

Attachments

  • 000_0186.JPG
    000_0186.JPG
    3 MB · Views: 154
 

Tractor & Equipment Auctions

2007 INTERNATIONAL MA025 DAY CAB (A51219)
2007 INTERNATIONAL...
2020 KUBOTA SSV75 WHEELED SKID STEER (A51242)
2020 KUBOTA SSV75...
2012 GENIE GTH-5519 TELESCOPIC FORKLIFT (A51242)
2012 GENIE...
2015 DODGE RAM 1500 CREW CAB TRUCK (A51406)
2015 DODGE RAM...
MT-500 Tack Trailer (A49461)
MT-500 Tack...
2000 TRAILKING TK110HDG-513 LOWBOY TRAILER (A50459)
2000 TRAILKING...
 
Top