Adding a second rear remote to dk45se

   / Adding a second rear remote to dk45se #1  

part-time-Farmer-NC

Platinum Member
Joined
Oct 7, 2024
Messages
570
Tractor
Kioti DK45Se
Perused through the old posts and didn't see an answer to my question.

I am contemplating getting/putting on myself a second set of rear remotes. I use the lever in the cab down by my right leg to control the current rear remote today. If I put on another one where is it controlled from? is that part of the installation to add a controller for it?
 
   / Adding a second rear remote to dk45se #2  
I'm not a Kioti guy so I don't know what your set up looks like. But you could use a multiplier to use your existing valve. You'd have a selector switch, and the switch setting would determine which connection your lever controlled.

Summit-Hydraulics.com is one vendor.
 
   / Adding a second rear remote to dk45se
  • Thread Starter
#3  
Thanks for the idea. I may head to my dealer and see how they come from the factory. Most of the ones my size only have the one, but I should be able to "see" how it works.
 
   / Adding a second rear remote to dk45se #4  
Mine has another lever right beside the 1st one for the second remote. On an open station I don't think it was a big job to add, as my dealer did it as part of the deal. One is self centering (I use it for the 3pt toplink) and the other has the detents which I've never used, but its for a 3pt splitter or back hoe. Someday I'll add a hyd side link and I'll have to figure out how switch the second lever to self centering.
 
   / Adding a second rear remote to dk45se #5  
Perused through the old posts and didn't see an answer to my question.

I am contemplating getting/putting on myself a second set of rear remotes. I use the lever in the cab down by my right leg to control the current rear remote today. If I put on another one where is it controlled from? is that part of the installation to add a controller for it?
The kit I bought came with the lever, on my DK4210, there was an empty slot next to the first rear remote. Lever went there, you add the hydraulic body, connect the lever to the body and run the lines out the back.

I added a couple of pictures here, unfortunately I didn't take a picture of the lever part.
 
   / Adding a second rear remote to dk45se
  • Thread Starter
#6  
Thanks for the information. I will continue to check it over and look for the minute details.
 

Tractor & Equipment Auctions

2008 BigTex Utility Trailer (A50860)
2008 BigTex...
2018 WACKER NEUSON CORPORATION DBA WACKER NEUSON LTV6 LIGHT TOWER (A50854)
2018 WACKER NEUSON...
2022 Club Car Tempo Golf Cart (A48082)
2022 Club Car...
2012 INTERNATIONAL 4300 26 FT BOX TRUCK (A51219)
2012 INTERNATIONAL...
2014 Chevrolet Silverado 1500 LT 4x4 Crew Cab Pickup Truck (A48081)
2014 Chevrolet...
2005 Big Tex 10PI 16ft. T/A Pipe Top Utility Trailer (A49461)
2005 Big Tex 10PI...
 
Top