beppington
Elite Member
It looks like you were pushing too hard in reverse, a lesson I learned the hard way, too: http://www.tractorbynet.com/forums/owning-operating/204404-ok-push-trees-over-box.html
Any GradeMaster owners here?
- Thread starter MotorSeven
- Start date
- Views: 24886
It looks like you were pushing too hard in reverse, a lesson I learned the hard way, too: http://www.tractorbynet.com/forums/owning-operating/204404-ok-push-trees-over-box.html
MtnViewRanch
Elite Member, Advertiser
- Joined
- Mar 19, 2005
- Messages
- 10,654
- Tractor
- Mahindra 7520, Mahindra 3215HST, Case 580 extendahoe, Case 310 dozer, Parsons trencher, Cat D6,
DPOCV is the only guarantee. I'm not sure about what size CCM would use for you, but I know that one of my cylinders is quite a bit stronger than the one that you bent. If your valve is good, leak down should not be a concern. My side links give you equal tilt to each side. Sounds like you are probably looking to get a unit from CCM though.
Good luck with making your decision.
OP
MotorSeven
Elite Member
Actually, no, I can replicate the issue without pushing hard at all. It has more to do the the box being angled down in the front and the terrain(like backing into a ditch to clean it out). Also, my hyd top link is not ridgid, but will compress when force is pushed into it. This is good when brush hogging, but not good in other situations.
After I fixed everything, I welded two 2"x4"x1/4" sections of angle iron on the BB arms in an effort to prevent it from flipping again. Both of those tabs are now bent down almost flat, so my next "stops" will be made out of boxed steel.
OP
MotorSeven
Elite Member
Ouch, I just read your thread. I really try and take it easy when backing/smoothing with a BB. I always have this fear of breaking the case especially when the BB catches a rock, and I have lots of rocks.
