mjfox6
Silver Member
Has anyone ever seen an automatic waterer like this one? Do you know who makes it? I'm trying to figure out how to clean it.
Nothing comes apart - it's "all" welded. What isn't shown well is it has 4 'openings'. It goes through the wall and the other side has two, just like the pic (It's symmetric about the wall shown).
Also not shown are two bolts that appear to bolt the whole thing to the cement floor. One is broken/missing. The wall goes across the center, so it doesn't seem like removing those bolts would be how to clean it.
That access hole (circled in red) is approximately the width of my 1st three fingers. "Just beyond" my finger tips there is what appears to be a rubber cork type thing. This 'cork' goes into the 'ceiling', meaning it would need to be pulled down to remove. It would not be easily reinserted and since I have yet to find the main water shutoff for the barn, I fear a large, unstoppable flood.
Nothing comes apart - it's "all" welded. What isn't shown well is it has 4 'openings'. It goes through the wall and the other side has two, just like the pic (It's symmetric about the wall shown).
Also not shown are two bolts that appear to bolt the whole thing to the cement floor. One is broken/missing. The wall goes across the center, so it doesn't seem like removing those bolts would be how to clean it.
That access hole (circled in red) is approximately the width of my 1st three fingers. "Just beyond" my finger tips there is what appears to be a rubber cork type thing. This 'cork' goes into the 'ceiling', meaning it would need to be pulled down to remove. It would not be easily reinserted and since I have yet to find the main water shutoff for the barn, I fear a large, unstoppable flood.
