B7800 3pt minimum height

[kody632]

Wondering if there is a way to adjust the 3 pt arms so that they will go a little lower. seems when using the box blade it is just a little bit too high. I looked over it tonight but did not see any obvious adjustments?

 

[whistlepig]

The lowest the 3PT on my B7800 will go is 10 1/2" measuring from the floor to the center of the "eye" on the lower lift arms.

 

[teg]

Something should be able to be adjusted to be able to loser them... have you asked your dealer about it?

 

[kody632]

Measured mine today, they are also 10.5"

Still haven't been able to figure out if I can get them to go lower... haven't asked the dealer yet either

 

[Leejohn]

Move upright rods into the front holes in the lower link arms..

 

[Craig Clayton]

I do not know that model but I think the arms are pulled up by the lift rods and they are splined on to the upper shafts. If you moved the arms 1 spline it would lower you arms, but I have never done it. Second idea If you made up a custom bracket where the lift arms connect on to the lower lift arms that would also lower the arms. I like my second idea best as it is the least intrusive.
Craig Clayton

 

[art]

Your lift links that connect to the lower arms have multiple holes and you can lower them that way!

 

[easygo]

THIS marks the lower lift links Art is talking about. You want them in hole #2 on both sides. That will lower the arms significantly.

 

[Verticaltrx]

THIS marks the lower lift links Art is talking about. You want them in hole #2 on both sides. That will lower the arms significantly.

Ditto. For those who wonder Kubota designed the front set of holes for maximum height/drop range, and the rear set for maximum lifting power. The bigger Kubotas have 3 sets of holes for this same purpose.

 

[kody632]

thanks to all for the reply... I'm a little embarrased that I over looked this, I was too focused linkage...