Band Saw Stand

   / Band Saw Stand #11  
Is there a notch in the wiring cover plate you can run the green through, then snug it under one of the plate-attaching screws? That would work.
Jim
 
   / Band Saw Stand #12  
You'll enjoy that stand and it looks excellent.

I usually fabricate a piece of fiberglass A/C filter on the air inlet end of the motor to prevent my wood working motors looking like this one. It looks as if I was a little late this time but later is better than never if it still runs.:D

They still need taken apart on occasion to be cleaned but not nearly as often.
 

Attachments

  • Motor (saw) dirty  1-4-2009.jpg
    Motor (saw) dirty 1-4-2009.jpg
    146.3 KB · Views: 102
   / Band Saw Stand
  • Thread Starter
#14  
Thank goodness for TEFC (Totally Enclosed Fan Cooled) motors.

Yeah. At work (food plant) we have wash down motors that can be hosed off while running and still survive. Unfortunately, this motor I have is not one of them. I may look for an opportunity to take it apart and clean it. Then I may take the advice to install some kind of makeshift filter.
 

Tractor & Equipment Auctions

2013 Big Tex 16GP-20 Gooseneck Trailer (A53117)
2013 Big Tex...
2016 John Deere 755K Crawler Loader (A47477)
2016 John Deere...
1994 Fontaine 48 ft. T/A Float Trailer (A53117)
1994 Fontaine 48...
Ferguson Rubber Tire Asphalt Roller (A52377)
Ferguson Rubber...
2007 Ford Focus Hatchback (A51694)
2007 Ford Focus...
Payment Instructions (A47477)
Payment...
 
Top