Bent check chain

   / Bent check chain #11  
Bedlam said:
SO Jerrys post with this item is either to expensive or isn't rugged enough?
Surplus Center Item Detail
It says it is designed for it..

ADJUSTABLE KUBOTA SWAY LINK TURNBUCKLE

May or may not be a deal, depends on if it is the correct size, it obviously isn't the same as the one the OP bent.....

That said $4 for just about ANY turnbuckle that large is a great price if you've priced generic ones lately:D I've got a few on the way just because...I might need some one day, for something....don't know what yet:eek:
 
   / Bent check chain #12  
Skyco said:
May or may not be a deal, depends on if it is the correct size, it obviously isn't the same as the one the OP bent.....

That said $4 for just about ANY turnbuckle that large is a great price if you've priced generic ones lately:D I've got a few on the way just because...I might need some one day, for something....don't know what yet:eek:
Thats is an awesome deal, I've got an order for a couple of these too. I was looking at Crosby turnbuckles recently for this same use and one that size was almost $60 each.
 
   / Bent check chain #13  
I would agree with those that say bend it back and see how it goes. I've bent a few of those and straightened them out with out a hitch. Take a torch heat it up and slowly straighten it in a vise. It will be close to good as new, From experience I have yet to actually replace one on a large machine, unless of course I snapped it in half while trying to straighten it. :)

Good luck!
Jim
 
   / Bent check chain
  • Thread Starter
#14  
Check chain straightened! I fix computers and the last stop today was at a machine shop. After replacing computer part I asked owner if he could straighten a threaded rod for me. He said it should not be a problem and we went over to a table vice/material holder and he took a look at the check chain and asked if it was from a Kubota. He then told me about his B3030 and I told him about my B2620.............He straightened the rod and ran a die over it to clean up the threads. Thanks George Abbott of Abbott Machine Shop in Conway, NH and thanks to everyone for their suggestions.
 

Tractor & Equipment Auctions

2014 Ford F-150 Ext. Cab Pickup Truck (A53422)
2014 Ford F-150...
2008 KZ Sportsman Police Bunk 5th Wheel Tri-Axle Travel Trailer (A54815)
2008 KZ Sportsman...
2014 Ford F-150 Ext. Cab Pickup Truck (A52377)
2014 Ford F-150...
43030 (A51691)
43030 (A51691)
2018 RoGator 1100C (A53473)
2018 RoGator 1100C...
LINDE WELDER (A53843)
LINDE WELDER (A53843)
 
Top