Bobcat 325G excavator code 65-06 "work group / lockout solenoid short to ground".

   / Bobcat 325G excavator code 65-06 "work group / lockout solenoid short to ground". #1  

shameless

New member
Joined
Feb 21, 2024
Messages
6
Tractor
john deere 3038e
The only solenoid I see in the repair manual is the system bypass solenoid. I unplugged it and the code did not change. If I have the right one I am thinking it must a wire shorted out. Does anyone know if this is the right solenoid and what ohm reading the coil should have? Thanks.
 
   / Bobcat 325G excavator code 65-06 "work group / lockout solenoid short to ground".
  • Thread Starter
#2  
I found the information needed and will be checking it today. Thanks
 
   / Bobcat 325G excavator code 65-06 "work group / lockout solenoid short to ground". #3  
If unplugging the system bypass solenoid didn't change the code, it might not be the issue. Double-check the solenoid you’re looking at to make sure it's the right one. The coil’s ohm reading usually ranges from 10-20 ohms, but you should verify with your manual. Also, inspect the wiring for any shorts or damage.By the way, I recommend that you choose the Bobcat 322 excavator instead of the Bobcat 325. If you wish, you can see the Bobcat 322 specs below.
 
Last edited:

Tractor & Equipment Auctions

STIHL TS420 CUTQUICK SAW (A50854)
STIHL TS420...
2022 Ford F-250 XL 4x4 Ext. Cab Pickup Truck (A49461)
2022 Ford F-250 XL...
RIGID TOOLBOX (A50854)
RIGID TOOLBOX (A50854)
2019 CATERPILLAR 259D SKID STEER (A51242)
2019 CATERPILLAR...
71065 (A49346)
71065 (A49346)
1042 (A50459)
1042 (A50459)
 
Top