The only solenoid I see in the repair manual is the system bypass solenoid. I unplugged it and the code did not change. If I have the right one I am thinking it must a wire shorted out. Does anyone know if this is the right solenoid and what ohm reading the coil should have? Thanks.
Bobcat 325G excavator code 65-06 "work group / lockout solenoid short to ground".
/ Bobcat 325G excavator code 65-06 "work group / lockout solenoid short to ground".
#2
john.doe112
New member
- Joined
- Aug 12, 2024
- Messages
- 3
- Tractor
- john deere 120d
If unplugging the system bypass solenoid didn't change the code, it might not be the issue. Double-check the solenoid you’re looking at to make sure it's the right one. The coil’s ohm reading usually ranges from 10-20 ohms, but you should verify with your manual. Also, inspect the wiring for any shorts or damage.By the way, I recommend that you choose the Bobcat 322 excavator instead of the Bobcat 325. If you wish, you can see the Bobcat 322 specs below.
Bobcat 322 Specs, Weight, Lift Capacity and Reviews | E-Machinery
Bobcat 322 specs, weight, lift capacity, and reviews are available here. Click here for more information on the Bobcat 322 excavator.
www.e-machinery.net
Last edited:
