BX FEL Dolly Help!
- Thread starter woodstock
- Start date
- Views: 3651
.jpg)
jyoutz
Super Member
Woodstock, I can't help you there. But since you have made them for other implements, could you share your design with me for a rototiller dolly? I'm getting ready to build one of these and right now I have a bad case of inventor's block.
Bird
Rest in Peace
Woodstock, someone in the last few months posted pictures of the one he made, but I don't remember who or where./w3tcompact/icons/frown.gif It looked real good, though.
Bird
Bird
Woodstock,
This is an interesting challenge. I haven't built one - but I have thought about it (daydreaming about getting a FEL for my BX). Unless you want lots of fussing around each time you take the FEL off, I would say that there are only a couple of ways to do this. First question is - what would you be making the dolly out of - lumber or steel?
Patrick
This is an interesting challenge. I haven't built one - but I have thought about it (daydreaming about getting a FEL for my BX). Unless you want lots of fussing around each time you take the FEL off, I would say that there are only a couple of ways to do this. First question is - what would you be making the dolly out of - lumber or steel?
Patrick
Harv
Elite Member
- Joined
- Aug 22, 2000
- Messages
- 3,346
- Tractor
- Kubota L2500DT Standard Transmission
Woodstock -
I betcha Bird is referring to this thread. Pictures and everything. /w3tcompact/icons/smile.gif
I betcha Bird is referring to this thread. Pictures and everything. /w3tcompact/icons/smile.gif
Bird,
Your memory is better than mine - or Woodstock's ... check out who posted in the thread below /w3tcompact/icons/wink.gif
Loader Dolly
Patrick
Your memory is better than mine - or Woodstock's ... check out who posted in the thread below /w3tcompact/icons/wink.gif
Loader Dolly
Patrick
I'm getting ready to make a dolly for my FEL too. I have found the dolly for my tiller is invaluable. I can hook up my tiller in seconds because I can micro adjust the position which I couldn't do if it was sitting on the floor.
I'm going to make the loader dolly the same way-- 2X6 on the flat glued and screwed together, 3/4 plywood also glued and screwed, and real heavy duty castors. The glue I have found from wood working greatly increases strength.
I'm going to make the loader dolly the same way-- 2X6 on the flat glued and screwed together, 3/4 plywood also glued and screwed, and real heavy duty castors. The glue I have found from wood working greatly increases strength.
Bird
Rest in Peace
Woodstock, I was bettin' one of these sharper fellows, like Harv & RPM, would find it for us./w3tcompact/icons/laugh.gif
Bird
Bird
theboman
Veteran Member
I LMAO on this thread thinking of a FRONT END LOADER and DOLLY. Think about it.
Bluegrass, Pick It Up!
Bluegrass, Pick It Up!