FarmerFrank
Member
I have a new BX2200. When it arrived I checked the Transmission Fluid level with the engine off. There was not enough in the system to reach the bottom of the Dipstick (the FEL would operate). I slowly added Kobota UDT and wound up having to put in 3/4 gal. Now the fluid registers above the "full" mark.
Questions: What kind of damage could delivering my BX so low on UDT have caused? The engine registered 1/2 hour. Should I be concerned?
Should I drain some UDT to get the level precisely between the indicators? Can too much UDT damage the transmission?
Do I have to use Kobota UDT? Are there other approved fluids?
Questions: What kind of damage could delivering my BX so low on UDT have caused? The engine registered 1/2 hour. Should I be concerned?
Should I drain some UDT to get the level precisely between the indicators? Can too much UDT damage the transmission?
Do I have to use Kobota UDT? Are there other approved fluids?