chain harrow question

[sixdogs]

That will work right well. Easy and fast. :thumbsup::thumbsup::thumbsup:

Picture of harrows on three point made by Farm King.
View attachment 503940

That is a great looking harrow and one you can pick up to clear the grass. Wish we had those down here. Any idea on the price?

 

[Egon]

That is a great looking harrow and one you can pick up to clear the grass. Wish we had those down here. Any idea on the price?

y

Can't answere on price but a small one was affordable some years back. They should be exported south. The lift would also be easy to make. Diamond harrow sections should be readily available.

 

[California]

A couple of years ago I fabricated a 3-point lift for my spike harrow. It has a full width bar to pull the thing, then four 8 inch chains go back from this towbar to the harrow itself.

This photo shows it lifted. The cable and pulley are off scrap exercise equipment and provide a compound lift when the 3-point is raised. I need this lift to make tight turns at the end of my orchard rows (after my neighbor fenced his place).

And here is a thread where I asked for advice.
There might be something in there to give someone a few ideas.
http://www.tractorbynet.com/forums/yanmar/218528-new-toys-spike-harrow.html

 

[sixdogs]

A couple of years ago I fabricated a 3-point lift for my spike harrow. It has a full width bar to pull the thing, then four 8 inch chains go back from this towbar to the harrow itself.

This photo shows it lifted. The cable and pulley are off scrap exercise equipment and provide a compound lift when the 3-point is raised. I need this lift to make tight turns at the end of my orchard rows (after my neighbor fenced his place).

And here is a thread where I asked for advice.
There might be something in there to give someone a few ideas.
http://www.tractorbynet.com/forums/yanmar/218528-new-toys-spike-harrow.html

I probably commented on some earlier post but that is an absolutely perfect spike harrow setup.

 

[Surreal001]

A couple of years ago I fabricated a 3-point lift for my spike harrow. It has a full width bar to pull the thing, then four 8 inch chains go back from this towbar to the harrow itself.

This photo shows it lifted. The cable and pulley are off scrap exercise equipment and provide a compound lift when the 3-point is raised. I need this lift to make tight turns at the end of my orchard rows (after my neighbor fenced his place).

And here is a thread where I asked for advice.
There might be something in there to give someone a few ideas.
http://www.tractorbynet.com/forums/yanmar/218528-new-toys-spike-harrow.html

My FIL has an 8ft spike harrow similar to that we use as a drag. I'm going to have to fab up a 3 pt setup for it. Great idea.

 

[Rford]

That is a great looking harrow and one you can pick up to clear the grass. Wish we had those down here. Any idea on the price?

I thought so too....$1000 or a little more new.

 

[California]

Great idea.

Thanks. And good luck with your project.

 

[robbyr]

Just curious.....
How do you mix in fertilizer with yours?

I only use it to knock down and spread out the cow patties.