Connecting non-standard hitch to my tractor

   / Connecting non-standard hitch to my tractor #1  

plowhog

Elite Member
Joined
Dec 8, 2015
Messages
4,048
Location
North. NV, North. CA
Tractor
Massey 1710 / 1758, Ventrac 4500Y / TD9
I bought a Berkelman off road dump trailer a while back. I am just now wanting to put it into service for some firewood work.

I went to connect it to the tractor and ... whoa ... I'm not sure how to do it? Here is a pix of the front tongue of the trailer. The end section that will take a pin will spin 360 degrees?

How would you connect it up?

BerkelmanHitchA.jpg
 
   / Connecting non-standard hitch to my tractor #2  
Must be so if the trailer flips it won't flip the ATV?

On edit: Sorry I didn't know you have never used your draw bar before, I thought you were asking why it spins 360..
 
   / Connecting non-standard hitch to my tractor #3  
That's a standard draw bar setup. Just slip the drawbar in between the forks and slip a pin through it.
 
   / Connecting non-standard hitch to my tractor
  • Thread Starter
#4  
Thanks! I've attached implements but never used a drawbar. Now to see if I have one ....
 
   / Connecting non-standard hitch to my tractor #5  
Thanks! I've attached implements but never used a drawbar. Now to see if I have one ....



image-2836284101.jpg



If you don't have one of these sticking out from beneath the rear axle, you can purchase one of these and attach it to the 3 pt.



image-2600561670.jpg
 
   / Connecting non-standard hitch to my tractor
  • Thread Starter
#6  
Thanks! I know I have the second bar that is pictured. I'll connect it up tomorrow and see how it fastens up!
 
   / Connecting non-standard hitch to my tractor #7  
If you use the 3 point drawbar with a trailer, you need to chain the 3 point arms down or you can get in a situation where the trailer lifts the arms along with the bar. A belly bar is the best way to go with it.
 
   / Connecting non-standard hitch to my tractor #8  
You'll be more stable over rough/uneven ground if you go with a draw bar.
 
   / Connecting non-standard hitch to my tractor
  • Thread Starter
#10  
That is very helpful, thank you. I looked at several of their videos looking for something like this. Yes, this one shows exactly how to do it. Perfect.

UPDATE: I found my (cab) tractor has a belly bar. (Did not check the SCUT yet.) It was pushed all the way forward, invisible unless you crawl under the tractor. I extended it backward and it will be the perfect matchup for the trailer. Thank you all again.
 
Last edited:

Tractor & Equipment Auctions

2006 Ford F-750 Terex Commander C1017 Digger Derrick Truck (A55973)
2006 Ford F-750...
42FT X 36FT METAL GARAGE BUILDING (A58214)
42FT X 36FT METAL...
2015 INTERNATIONAL FLATBED (A58214)
2015 INTERNATIONAL...
2002 Henderson 8X Mild X Sandspreader Attachment (A55973)
2002 Henderson 8X...
3 PT SCRAPE BLADE (A58374)
3 PT SCRAPE BLADE...
MARATHON 20KW GENERATOR (A58216)
MARATHON 20KW...
 
Top