Connecting non-standard hitch to my tractor

   / Connecting non-standard hitch to my tractor #1  

plowhog

Elite Member
Joined
Dec 8, 2015
Messages
4,048
Location
North. NV, North. CA
Tractor
Massey 1710 / 1758, Ventrac 4500Y / TD9
I bought a Berkelman off road dump trailer a while back. I am just now wanting to put it into service for some firewood work.

I went to connect it to the tractor and ... whoa ... I'm not sure how to do it? Here is a pix of the front tongue of the trailer. The end section that will take a pin will spin 360 degrees?

How would you connect it up?

BerkelmanHitchA.jpg
 
   / Connecting non-standard hitch to my tractor #2  
Must be so if the trailer flips it won't flip the ATV?

On edit: Sorry I didn't know you have never used your draw bar before, I thought you were asking why it spins 360..
 
   / Connecting non-standard hitch to my tractor #3  
That's a standard draw bar setup. Just slip the drawbar in between the forks and slip a pin through it.
 
   / Connecting non-standard hitch to my tractor
  • Thread Starter
#4  
Thanks! I've attached implements but never used a drawbar. Now to see if I have one ....
 
   / Connecting non-standard hitch to my tractor #5  
Thanks! I've attached implements but never used a drawbar. Now to see if I have one ....



image-2836284101.jpg



If you don't have one of these sticking out from beneath the rear axle, you can purchase one of these and attach it to the 3 pt.



image-2600561670.jpg
 
   / Connecting non-standard hitch to my tractor
  • Thread Starter
#6  
Thanks! I know I have the second bar that is pictured. I'll connect it up tomorrow and see how it fastens up!
 
   / Connecting non-standard hitch to my tractor #7  
If you use the 3 point drawbar with a trailer, you need to chain the 3 point arms down or you can get in a situation where the trailer lifts the arms along with the bar. A belly bar is the best way to go with it.
 
   / Connecting non-standard hitch to my tractor #8  
You'll be more stable over rough/uneven ground if you go with a draw bar.
 
   / Connecting non-standard hitch to my tractor
  • Thread Starter
#10  
That is very helpful, thank you. I looked at several of their videos looking for something like this. Yes, this one shows exactly how to do it. Perfect.

UPDATE: I found my (cab) tractor has a belly bar. (Did not check the SCUT yet.) It was pushed all the way forward, invisible unless you crawl under the tractor. I extended it backward and it will be the perfect matchup for the trailer. Thank you all again.
 
Last edited:

Tractor & Equipment Auctions

DECORATIVE METAL GATE (A58214)
DECORATIVE METAL...
Dewalt 14" Chop Saw (A59076)
Dewalt 14" Chop...
2025 LandHonor RB-14-66W 66in Rock Bucket Skid Steer Attachment (A56857)
2025 LandHonor...
Toro Groundsmaster 4000D (A56857)
Toro Groundsmaster...
40' Connex Box, Asset# 32 (CONTENTS NOT INCLUDED - DELAYED REMOVAL, CONTACT SITE MANAGER) (A59076)
40' Connex Box...
PALLET OF MISC PARTS (A58374)
PALLET OF MISC...
 
Top