I finally got time to install the new seat on my L3700. It took a few hours and a few "field adjustments" to get it to fit. All in all, I like it. It has a small lever to recline the back that I need to bend inward because it interferes slightly with the rear PTO lever if it's engaged. And the Hydrostatic lever is up against the left side of the seat bottom when in low gear. It's certainly useable as it is.. but a little more fine tweaking and it will be as good as factory.
Crazy price on great seat!
- Thread starter LS Tractor Owner
- Start date
- Views: 16073
aczlan
Good Morning
- Joined
- Mar 7, 2008
- Messages
- 16,985
- Tractor
- Kubota L3830GST, B7500HST, BX2660. Formerly: Case 480F LL, David Brown 880UE
The one on the lawnmower was short lived, the operator snagged the swing set with the seat and the bolts ripped through the sheet metal of the fender area
Next up: A piece of flat bar across underneath to bolt it to.
Aaron Z
Next up: A piece of flat bar across underneath to bolt it to.
Aaron Z
TractorGuy
Elite Member
- Joined
- Sep 15, 2013
- Messages
- 4,591
- Location
- N. FL
- Tractor
- John Deere 4310 CUT, Ford New Holland 575E Industrial Backhoe, John Deere F725 Front Mount Mower
Did this seat have provisions for a seat switch?
Not sure what you mean by seat switch ? ..But my new one came with 2 cross members bolted to the bottom and a set of slides bolted to the cross members. .. I discarded the new slides on my install.
aczlan
Good Morning
- Joined
- Mar 7, 2008
- Messages
- 16,985
- Tractor
- Kubota L3830GST, B7500HST, BX2660. Formerly: Case 480F LL, David Brown 880UE
It has a hole for one, I adapted the switch on the Deere rider to make to fit.
Aaron Z
