Santa Craig Cringle
Silver Member
Greasing my CX2510 HST open station at the 50 hour service interval. Been greasing the loader every 10 hours but the manual says grease the undercarriage points every 100. I figured I’d go and get them.
The manual also shows several points I can’t find. So far I’ve spotted the two in front and back of the front axle and the brake lever. I don’t see anymore. Am I missing any?
Also I have a battery powered grease gun. On the two right angle zerks at the axle it seems to pull a vacuum. Hose gets real tight and it’s hard to pull off the zerk at that point. I can’t see where any grease is coming out. Does this indicate it’s not taking grease or that it’s sealed and completely full?
The manual also shows several points I can’t find. So far I’ve spotted the two in front and back of the front axle and the brake lever. I don’t see anymore. Am I missing any?
Also I have a battery powered grease gun. On the two right angle zerks at the axle it seems to pull a vacuum. Hose gets real tight and it’s hard to pull off the zerk at that point. I can’t see where any grease is coming out. Does this indicate it’s not taking grease or that it’s sealed and completely full?