DIY backhoe dolly

[Devi8]

I made one this summer as well. The CB05 is a HEAVY backhoe, I intend on making one out of metal when I get some time.

 

[Devi8]

Also made a loader cart as well.

 

[Gofast]

View attachment 583470

I made one this summer as well. The CB05 is a HEAVY backhoe, I intend on making one out of metal when I get some time.

Nice looking dolly.

 

[Xfaxman]

View attachment 583471

Also made a loader cart as well.

Try again, the picture didn't upload.

 

[dragoneggs]

I'm no help here... I splurged on a BXpanded dolly specifically made for my BH. I wasn't sure how precise the height needed to be. I am happy with it because I can remove/install it in a couple minutes. Knowing what I know now, I would have saved money on a DIY welded square tube frame. :ashamed:

 

[check]

I'm no help here... I splurged on a BXpanded dolly specifically made for my BH. I wasn't sure how precise the height needed to be. I am happy with it because I can remove/install it in a couple minutes. Knowing what I know now, I would have saved money on a DIY welded square tube frame. :ashamed:

Yup. I bought the same BXpanded BH dolly. Works great!

 

[Devi8]

Try again, the picture didn't upload.

fixed

 

[Xfaxman]

fixed

:thumbsup:

 

[PJohnson]

Sorry for the delay responding. Thank you. It was very helpful.

 

[vrtlhntr]

I know this is late, but here's my version of a Kubota BH92 backhoe dolly. Not for everyone, but I designed it into 2 pieces for compact storage. I've used two ratchet straps. One for the outriggers and another that forces the boom against the backhoe mainframe via a notch on the backside of the boom keeper. Once in place it is very stable and moves easily. I chose to catch the dolly at the pins of the backhoe frame where it is the widest point of the backhoe. Do not attempt to design this unless you fully understand this.