Does anybody know what kind of connector this is? Where to buy?

[Mechanos]

Great! Would it be the 14-16 gauge terminals?

That depends on the wires you're attaching them to. What gauage are the wires on the light?

 

[Zebrafive]

If you have to have the mating connector (plastic part) JD dealer should have it and the proper terminals for it. But expect to PAY more than online.

 

[Mechanos]

The Packard 56 Series connectors were used on millions of older cars. I trip to the local junkyard would probably net you all the connectors you'd care to carry.

 

[techwrtr2]

I would do the Weatherpak personally... I have a similar connector on my 855 for the rear work light and it's problematic. Weatherpak would seal it and likely prevent problems.

And replace that seat belt!

 

[Scooby074]

Yep. Another vote for cut off the old and replace with a weatherpak connector.

 

[twlyons1]

It's not that hard. Just put female spade connectors on the wires coming off of your work light and they should fit right into the installed connector on your tractor. You don't need a special plug. I just did this on my 770.

I would too how ever the plug he is holding has female connectors in it so I am guessing you ment male 1/4 inch spade connectors on the light.