ROGERCORBETT
New member
Does anyone have any experience with software from GPT Consulting. It sells software and a tuning tool that modifies the engine control module file pertaining to the emission system.
Engine control module file modifications.
- Thread starter ROGERCORBETT
- Start date
- Views: 1835
Tx Jim
New Member
Are you aware of this story concerning a detuned pickup truck destined for SMASHER?
www.motorbiscuit.com
Illegal "Deleted" Ram Diesel Owner Wants It Crushed Rather Than Comply
The owner of this diesel defeat Ram 2500 pickup had a choice between compliance or crushing. He chose crushing.
www.motorbiscuit.com
ericm979
Super Member
I didn't see anything on the GPT site that would get the file off the ECU or install the new one. That can be tricky. In road vehicles the manufacturer often tries to make that difficult. It may be easier with off road vehicles. I'm suspicious that they offer tunes for so many vehicles. Usually a tuner will specialize in a relative few number of makes. They need to test on a dyno with a vehicle to get it right. The ECU files are not generic, they're specific to the ECU and the model of vehicle.
The going rate for a tune for a car is roughly in the $500 range, plus about the same for the tuner hardware that installs the tune.
I've had some cars tuned. Some of the tunes were CARB approved, some not. When you make a non approved mod one should make sure it's possible to undo the mod.
The going rate for a tune for a car is roughly in the $500 range, plus about the same for the tuner hardware that installs the tune.
I've had some cars tuned. Some of the tunes were CARB approved, some not. When you make a non approved mod one should make sure it's possible to undo the mod.
