error code

[24 frames]

Good morning LS xr 4140 with 556 hours tractor in limp mode error code s 97 F04 I did complete service oil change, air filters, fuel filter disconnect battery hoping for a reset but still in limp mode 1400 rpm's I am 66 in need of adult supervision thanks to all

 

[Eagle1]

Could not find S 97 F04 but all S 94 error (F01 F02 and F03) seem to indicate water in fuel

 

[alexpops]

Try changing the fuel filter, repriming the system & see if that clears the limp mode & code.

 

[24 frames]

Already Changed fuel filter I think next I will drop and clean fuel tank and the water sensor connections Thanks Eagle1 and pops

 

[alexpops]

Before dropping the tank, check the electrical connection to the water sensor. That can throw a code if not connected or excess resistance is messing with the signal to the ecu.

 

[GS650GL]

S97 F2 or F11 means water detected in fuel. S97 F3 or F4 means water in fuel sensor fault. So either you have a bad connection or bad wire, or the sensor is bad. Never have seen these sensors fail, so most likely a wire issue.

 

[5030]

Sounds to me like it's the old paper clip jumper time...