Everything Attachments

[darmstrong2319]

I really do not have an accurate estimate/calculation.
I can say that I talked to a guy with a new 72" EA Cutter earlier today and he said it's cut had people thinking he used a finish mower!
Travis

Thanks Travis

 

[lostcreekranch]

Do you know the blade RPM or gear ratio between PTO input and spindle? Calculating angular velocity with that info should be pretty straightforward.

Rob

And distance from blade tip to center of spindle.

 

[EverythingAttachments]

Do you know the blade RPM or gear ratio between PTO input and spindle? Calculating angular velocity with that info should be pretty straightforward.

Rob

Looks like 1:1.146.
Travis

 

[EverythingAttachments]

And distance from blade tip to center of spindle.

I'll get this when they have one hanging for assembly downstairs!
Travis

 

[lilranch2001]

Not available via CAD?

 

[BigBlue1]

OK, with 1:1.146 that means the blade holder is spinning at 619 RPM. However, when I went to look at the specs of the 72" mower things get a bit odd because the manual says the blade holder is 20.25" and the blades are 17.75". Not sure how that combo gets you to 72" width? Unless this is different than the skidsteer brush mower I've used in the past which had one big holder on a single spindle with 3 swinging blades attached. If this has multiple spindles then we'd have to know the spindle-to-blade-tip length as noted.

Rob

 

[lilranch2001]

I sent a PM looking for a post hole auger

 

[capecodtig]

I am looking for a hydraulic hose diagram for a 1620 backhoe attachment

 

[J W Bishop]

I just placed my order for the 55" Wicked Root Rake Grapple. Anxiously awaiting the arrival, about 5 weeks out. Can't wait to see what it will do to these gall berry bushes that are all over our property.

 

[EverythingAttachments]

I am looking for a hydraulic hose diagram for a 1620 backhoe attachment

I wish I could help you. You'll have to get it from the backhoe manufacturer.
Thanks for the inquiry!
Travis