FEL Float Mode

   / FEL Float Mode #11  
Practice with the bucket about 1 foot off the ground to keep from doing wheelies, once you get the hang of it you can do it while its on the ground.
 
   / FEL Float Mode #12  
Mine drops faster than I'd like.. I usually start with it on the ground or close to it.

Sean
 
   / FEL Float Mode
  • Thread Starter
#13  
You guys are WICKET SMAAART I couldn't wait to go out this morning and test it out...I snapped that stick forward like I meant it and Viola!!! Bob's your Uncle!!

Thanks to all who replied!!

Cheers,
BN
 
   / FEL Float Mode #14  
You have to have your bucket right at ground level, then throw into float quickly. If you don't do it quick it will start to raise the tractor. Float relieves hydraulic pressure, having only the weight of the loader holding it down, thus "floating".
That's why if you have the bucket raised, it will drop freely!

That is what I do.
 
   / FEL Float Mode #15  
Op's hand must only have the slow motion feature.
 
   / FEL Float Mode #16  
Whats the use for the float mode? Gotta try this.
 
   / FEL Float Mode #17  
Whats the use for the float mode? Gotta try this.

Many, but back dragging with the bucket is one. You can use it to evenly spread gravel or dirt. It is not a box blade, and won't move a large amount of materiel but you can adjust the bucket angle a bit to move a bit more or less material. Here is a very short demo of an old fat boy smoothing out some gravel by traveling in reverse with the bucket in "float" with some angle on the bucket.

https://www.youtube.com/watch?v=7Wh-Y0d-pfw
 
   / FEL Float Mode #18  
I use mine with bucket skid shoes for moving snow, it maintains the same height with no adjusting. Backdragging sand is another use.
 
   / FEL Float Mode #19  
I use float when plowing snow or using my snowblower. Stops the implement from digging into the ground.
 
   / FEL Float Mode #20  
k0ua, yep, float is very useful for gravel etc, for leveling.
If I see the ground is not quite level and find float rides the "hill's", here's what i do...
I start at a level spot, drop the bucket "in float" then remove the "float" function and add just a "little'
down pressure, this will keep a level field for those "little' hill's,
then, repeat, but in float only.
It takes practice but works well.
 

Tractor & Equipment Auctions

Double L 30”x25’ Conveyor (A47369)
Double L 30”x25’...
2003 Subaru Outback AWD Sedan (A46684)
2003 Subaru...
2015 Kia Optima Sedan (A46684)
2015 Kia Optima...
2022 Chevrolet Tahoe SUV (A46684)
2022 Chevrolet...
2005 Ford Ranger Ext. Cab Pickup Truck (A46684)
2005 Ford Ranger...
2015 Ford F-750 Terex Hi-Ranger 5TC-55 55ft Bucket Truck (A46683)
2015 Ford F-750...
 
Top