Filter For Hydraulics

[Momboy007]

Hello All,
I have yet another question concerning my Jinma 304?
I have a Japanese loader installed on my tractor, I think it called an AG3????, anyhow, I have a filter near the starter on the right hand side of the motor, Do I still need to clean out a mesh filter somewhere, or should I remove it??
Thanks all in advance,
Rick

 

[RonMar]

I would guess that if you have a spin on strainer can on the pump suction line, that you do not have a suction strainer in the tank.

I am not familliar with exactly where your hydraulic system draws fluid from the 3PH lift box. The 200 series draws fluid out of the top of the box and there is a 3 bolt flange plate on the top front corner. There is a pipe fitting and plumbing that runs forward to the pump. Attached to the bottom of the plate is a suction pipe with a strainer (brass screen)attached. I know some of the larger machines draw their fluid from the side of the box behind a similar plate and require that you drain the resovoir to remove that plate.