Ford 3000 pto quit

[kurtwellnitz]

I have a Ford 3000 tractor and the PTO quit. The spline will still spin but not engage. Shortly after, the three point lift arms quit. I have been told that it probably is a clogged filter but dont know location or how to replace. Thanks for any help.

 

[Muhammad]

Welcome to TBN.

 

[mostly_gas]

Welcome to TBN.
It would be a good idea to move this tread to the New Holland section for more input.
I don't understand what you mean not engaging. When you move the PTO lever and release the clutch (with implement hooked up) what happens?

 

[Briana03]

Hey Kurt! WELCOME to TractorByNet.com!

I have moved your thread to the New Holland Owning/Operating Forum. You'll get a better response there.

 

[showcattle]

Check the to see if there's enough fluid in the rear end. That's where I'd start.

 

[whodat526]

fluid as nothing to do with the pto if it is not engaging u should look at the shaft and the splines and it and the sliding collar inside the read end

 

[Soundguy]

what trans does this tractor have?

soundguy

 

[Soundguy]

fluid as nothing to do with the pto if it is not engaging u should look at the shaft and the splines and it and the sliding collar inside the read end

fluid -DOES- matter.. if it is an SOS tractor with independent pto and hyd clutch pack...

we need to know more info...

soundguy

 

[whodat526]

fluid -DOES- matter.. if it is an SOS tractor with independent pto and hyd clutch pack...

we need to know more info...

soundguy

if if was a fifth we would all be drunk but yea need to know what trans is in it