lilranch2001
Super Member
- Joined
- Nov 25, 2009
- Messages
- 6,200
- Tractor
- Bobcat CT 235
looks like a funnel I made in High School shop class.
Thanks for bringing that memory back!
Thanks for bringing that memory back!
Funnel: I decided to make a good one
- Thread starter LD1
- Start date
- Views: 4618
k0ua
Epic Contributor
Good job LD1, I would have fun welding them up, but I don't have the equipment or the patience to make the pieces.. Again looks good.
James K0UA
James K0UA
bullbreaker
Elite Member
:thumbsup: That funnel sure came out nice !
Boone
Boone
chad22
Veteran Member
He sure would. That's a great looking funnel. I might have to have a go at one one of these days.
Chad
k0ua
Epic Contributor
I could help a little if you have questions. I have been down the road so to speak. Did a lot of research, had a lot of questions..
James K0UA
I was going to start another thread asking about TIG but I guess we can do it here... LD1, do you want to share your set up that you used to make the funnel? (...no rush 
) Do you use the DC machine for power and some other wire feed??? (I have not ever looked into it).
) Do you use the DC machine for power and some other wire feed??? (I have not ever looked into it).
k0ua
Epic Contributor
I was going to start another thread asking about TIG but I guess we can do it here... LD1, do you want to share your set up that you used to make the funnel? (...no rush
Teg, the wire feed on all TIG processes is you left hand. If you have ever done OA welding, it is much the same. Form a puddle, move the "heat" in the direction of the joint, an dip into the leading edge of the puddle. There is also a "laywire" technique to just lay the wire over the joint and advance the puddle into the wire. Do NOT, let the tungsten dip into the puddle or the fill wire.
James K0UA
OP
LD1
Epic Contributor
Yep, left hand is the wirefeed. Machine is just a little miller maxstar DC tig welder. I am no pro. I dont Tig everyday like some, but I can stick some peices together:laughing:
jkis
Bronze Member
- Joined
- Feb 19, 2012
- Messages
- 57
- Location
- booral, nsw, australia
- Tractor
- foton/euro lepard 250 and massey ferguson 65
nice job and a handi implemet too, anothe project goes on my want list
if you use some masking tape or similar and create an air space on the inside of the object your welding, you can run another line into it to purge the air out, by starting at the free end, but on the outside, the tape will burn, but a nice job both sides
cheers stuart
if you use some masking tape or similar and create an air space on the inside of the object your welding, you can run another line into it to purge the air out, by starting at the free end, but on the outside, the tape will burn, but a nice job both sides
cheers stuart
