So. It was -5F earlier this morning, and about 2F when I finally got out to try the cold start. While not definitive, it took at least 20 seconds for plugs to be hot enough for the cold start this morning. I cracked the throttle about 1/4 and I tried 10 seconds, then 15, and after the 20 seconds, I got a good start. As tomorrow will be another cold one, I will try once more, and go with 20+ for the first try.
Once started, I wanted the engine to warm up some and I got a chance to answer a long term question. And that has to do with the HOBBS meter. They are calibrated in 1/10 of an hour units or each tenth is 6 minutes. I had mentioned once before that I questioned how the meter worked as I was pretty sure that when the engine was running at low RPM, the meter was not clocking true hours.
Member newbury had said: "Just make sure how the hour meter on the equipment runs.
For example some tractors only count hours at full PTO speed."
Supposedly, my engine is at full power at 2900 RPM. While the engine was running, set at about 2000 RPM, I got my cell phone out and set it to a stop watch and waited for the HOBBS to turn 1/10th. When it did, I started the stop watch. When it turned again, to the next 1/10th, I stopped it. If my HOBBS only works correctly at full RPM, by simple math, at 2000 RPM, the HOBBS should have changed at about 8.7 minutes. As I am not sure the exact RPM, I was somewhat pleased when the meter turned at 8min 2seconds. Working that backwards, I estimate my engine was probably running about 2175 RPM. Ahhh...the things I do when I have way tooooo much time on my hands! Isn't retirement fun!
Once started, I wanted the engine to warm up some and I got a chance to answer a long term question. And that has to do with the HOBBS meter. They are calibrated in 1/10 of an hour units or each tenth is 6 minutes. I had mentioned once before that I questioned how the meter worked as I was pretty sure that when the engine was running at low RPM, the meter was not clocking true hours.
Member newbury had said: "Just make sure how the hour meter on the equipment runs.
For example some tractors only count hours at full PTO speed."
Supposedly, my engine is at full power at 2900 RPM. While the engine was running, set at about 2000 RPM, I got my cell phone out and set it to a stop watch and waited for the HOBBS to turn 1/10th. When it did, I started the stop watch. When it turned again, to the next 1/10th, I stopped it. If my HOBBS only works correctly at full RPM, by simple math, at 2000 RPM, the HOBBS should have changed at about 8.7 minutes. As I am not sure the exact RPM, I was somewhat pleased when the meter turned at 8min 2seconds. Working that backwards, I estimate my engine was probably running about 2175 RPM. Ahhh...the things I do when I have way tooooo much time on my hands! Isn't retirement fun!
Mtsoxfan
Veteran Member
Where in VT are you. Just got in and we are still at -8. Better than -18 at 3 am. At least the wind stopped.
Mtsoxfan
Veteran Member
We're as bit further north. Currently -7 in shade. We're at about 1600' but on an east ridge, so wind is plentiful all year round. Damn snow drifts. I was only up at 3 because catalyst on woodstove plugged and issues arose. About to bundle up and see how far I want to snowshoe. Wind picked up, so may be short lived. Hope the weather guessers are off on their amounts of snow tomorrow evening.
Well, your 1600ft level explains part of it. From my days as a 'student' pilot, I remember that there was approximately a 3°C drop (or 5.4°F) for every 1,000 feet gained in elevation under dry conditions, up to a certain altitude. If it's snowing or raining, the decrease is about 1.8°C (or 3.3°F) for every 1,000 feet. That is why, if you happen to be flying in a passenger airline at 35-40MASL, and the little screen on the seat back in front of you shows some bizarre outside temp of say -40F, you now know why.
While you are correct about the 'weather guessers', it appears we in VT will be in the white by later Monday! Let's hope the tractor starts and no problem arise with the snowblower!
Mtsoxfan
Veteran Member
Never made it out of negative numbers. -6 was the "high".
grsthegreat
Super Star Member
Last year my tractor struggled to start since fall. I wasn’t able to get around to changing the plugs until this spring. Major difference. Today was 12°f, tractor fired up without any issues. Acted like brand new. 10 second auto timed glow cycle, fired off beautifully.
Here are some similar links:
