rswyan
Super Star Member
- Joined
- May 12, 2004
- Messages
- 12,194
- Location
- Northeast Ohio
- Tractor
- Kubota B2910, Cub Cadet Pro Z 154S, Simplicity 18 CFC, Cub Cadet 782
Kyle,
Thanks.
I did a complete strip down of the carb this afternoon ... including the needle, H and L adjustment screws, throttle and choke plates and their rods. Basically anything that I could take off, I took off.
Carb is currently over @ PineRidge's, sitting in his can of Berryman carb cleaner. Will pick it up tomorrow afternoon.
Thanks.
I did a complete strip down of the carb this afternoon ... including the needle, H and L adjustment screws, throttle and choke plates and their rods. Basically anything that I could take off, I took off.
Carb is currently over @ PineRidge's, sitting in his can of Berryman carb cleaner. Will pick it up tomorrow afternoon.
Sounds good - will do :thumbsup:You might be able to clean the carburetor, if you can get the smallest orifices cleaned. I "pluck" a thin wire from my fine wire brush with my needle nose and use it to poke into the idle circuit orifices. Also use carb cleaner with brushes and compressed air. WEAR SAFETY GLASSES to keep solvent from getting into your eyes.