triniman
New member
Hi to all, it is good to be in good company. I am from Trinidad. I got a Ford 6600 October 2011, then a brushcutter, then a plow. I am learning lots since.
Learned to brush cut, learned to change pto clutches, learned to plow, learned to pull hydraulic lift clynder.
I have a question about the hyd. lift control, it responds correct when lowering, but it raises in increments, and with toying of speed control and lift lever.
Any ideas?
Learned to brush cut, learned to change pto clutches, learned to plow, learned to pull hydraulic lift clynder.
I have a question about the hyd. lift control, it responds correct when lowering, but it raises in increments, and with toying of speed control and lift lever.
Any ideas?
