Hello From WV

   / Hello From WV #1  

vegaome

Silver Member
Joined
May 27, 2012
Messages
158
Location
New Martinsville, WV
Tractor
1970 MF-135 and 1951 Ford 8N
Howdy Folks,

I live in the woods in WV and I'm looking to buy my first big tractor. Big to me is anything bigger than a garden tractor. I only have 57 acre farm but its pretty steep and mostly woods at the moment. I was thinking about getting a MF 135 or a Ford 3000. I enjoy reading the forums and all the help and advice people give. Thank you for your time.

v/r

Mike Daugherty
 
   / Hello From WV #3  
Welcome to TBN. As you can see, I'm partial to the Massey 135.
 
   / Hello From WV #6  
Welcome to the TBN forums from Missouri. :)

We have tried 2WD on our hill farms twice; sold one and moved one to our flat land farm; good luck.
 
   / Hello From WV
  • Thread Starter
#7  
Thank you for the welcome everyone. Someday I would love to get a 4WD tractor. I do have to live within my means though. I see folks that get plenty done with smaller 2WD tractors and that's what I can afford right now.
But by all means don't let that deter you from voicing your opinion. The only big tractor I drove was an Oliver cleat tractor when I was a teenager. It did not even have a steering wheel. I have a big learning cure ahead but I have a couple neighbors who have tractors and can show me the ropes. Plus my fear of it rolling over on me. I will let everyone know what I end up with.

v/r

Mike Daugherty
 
   / Hello From WV #9  
Hello Mike, welcome to TBN from Oklahoma. I'm partial to the MF, but the Ford is a good tractor too.

Ken
 
   / Hello From WV
  • Thread Starter
#10  
Well Folks,

I put a 100 dollars down on a MF135 the other day. The right front hub is busted and the folks said the part should be in soon and they will put it on. Then I will go back and give her a good test drive and finish the deal. Its an older one. Gas tractor, 6 speed, bug head lights. The two stage clutch does work properly but not sure who much clutch is left. The three piont kind of works, the raise/lower lever is stuck in the up position so to lower you use the draft. Not sure what the hang up is there. I assume its the continental engine. The sheet metal is pretty beat up. It does have new tires all the way around. I forgot to mention, no muffler and the tach/hour meter does not work. All the other gauges seem to be working. I hope I can get some work out of her. Have a good day.

v/r

Mike
 

Tractor & Equipment Auctions

2013 MACK CXU (A50854)
2013 MACK CXU (A50854)
2016 CATERPILLAR 259D SKID STEER (A50458)
2016 CATERPILLAR...
2021 Cat D5 LGP Dozer (RIDE AND DRIVE) (A50774)
2021 Cat D5 LGP...
2000 Dnya RGN (A49461)
2000 Dnya RGN (A49461)
TAKEUCHI TB2150 EXCAVATOR (A51242)
TAKEUCHI TB2150...
2015 FREIGHTLINER CASCADIA TANDEM AXLE DAY CAB (A51219)
2015 FREIGHTLINER...
 
Top