Help with old Disk Harrow bearing indentification

[seanhoffman]

I need some help identifying my harrow bearing. My harrow is a 16 disk three point heavy duty....it is at least 20 years old. The bearing is flanged, bolted to a L shaped bracket. It is a friction bearing(not sealed) and there are two of these per gang. I have looked at all the web sites i could find with no luck......so im asking you.....

 

[flusher]

I need some help identifying my harrow bearing. My harrow is a 16 disk three point heavy duty....it is at least 20 years old. The bearing is flanged, bolted to a L shaped bracket. It is a friction bearing(not sealed) and there are two of these per gang. I have looked at all the web sites i could find with no luck......so im asking you.....

I ran into a similar problem with my Minneapolis Moline KS-1300 wheel disc a few years ago. An outer bearing was a mess. Couldn't find a replacement. So I rigged up a bushing.



Good luck.

 

[deere5105]

There are a few local places where I could take the old bearing and have it matched up for a replacement. If unable to find something online, might check around to see parts house could help match it or recommend someone who can.

 

[Tact]

I need some help identifying my harrow bearing. My harrow is a 16 disk three point heavy duty....it is at least 20 years old. The bearing is flanged, bolted to a L shaped bracket. It is a friction bearing(not sealed) and there are two of these per gang. I have looked at all the web sites i could find with no luck......so im asking you.....

Pics would help.

 

[bambie]

I ran into a similar problem with my Minneapolis Moline KS-1300 wheel disc a few years ago. An outer bearing was a mess. Couldn't find a replacement. So I rigged up a bushing.

View attachment 245379View attachment 245380View attachment 245381View attachment 245382

Good luck.

looks like it is a 1" shaft you should be able to go to any indrustrial place that carry bearings and get a flange mount bearing self aligning, you may have to fabricate a plate to bolt it on these bearings are very cheep

 

[seanhoffman]

Thanks everyone. I stopped by TSC and did some more research. It appears that I have a fairly common flanged bearing. Although the actual bearing I need will take some doing, I think i have it figured out.

Thanks again.....Sean